开云体育

Dennis, Sounds like you have an ubitx. Please verify your kit model. My Bitx40 doesn't have these extra parts but my ubitx does. Big difference in wire up instructions. Paul KL7FLR

Just to add I received my Smarti PI Touch case for original PI Touchscreen I bought few years back and haven’t used because it was flemzy and awkward. This new case not only mounts screen with PI

Hi This spreadsheet of expected voltages is useful, but is there a table of expected voltages for the actual test point numbers?? TP1, TP2, etc.? This would be even more?useful as, on the v4 board,

Thanks Jack.

Try here, about half way down the page: amunters/bitx40-raduino-v2 | | | | | | | | | | | amunters/bitx40-raduino-v2 Raduino sketch v2 for bitx40 with digital BFO. Contribute to

My BITX40 v 4c kit has three resistors and a diode loose in the package of connectors and other parts. I have not been able to find any instructions as to where these resistors should be installed.

I left the word NOT out...! Sorry 'bout that. Jack, W8TEE

Jim, Why a separate AM detector? When the reference oscillator is calibrated then you just tune to the carrier frequency and it is zero beat. I've been listening to broadcast on the BITX since I

Dave is correct in that JackAl does support CAT control...yet. My guess is that some people are working on that. Jack, W8TEE

Jim, Would you kindly share your findings. 73, Bob GM4CID

Hello, A lot of folks here not only have ubitx, bitx, SDR, etc.... this post may be of use for some. If you have Raspberry PI and use for SDR or other things a company now sells a 24bit ADC / DAC

Thank you!

Brutus, Right now, to my knowledge, the stock JackAl firmware does not support rig (CAT) control. There's plenty of memory left, and I know of 1 party that's working on it, and I'm sure there's very

Use this one:

I have two of these cases, one for a Bioenno 20A LiFePo4 battery, charger, and power pole to (VHF/UHF) "T" & power pole to HF 4 pin power adapters, for powering radios when working 'picnic table

Hi Jack, this might be the wrong place to ask, but I'm thinking of getting the Jackal when I order the v5 board.? Does the Jackal implement rig control protocol via the usb port like the cec firmware

Pat, They are talking about the latest ?BITX version.? Judging by the price it looks like you are talking about the BITX40.? Either way the choice is right on the order page ? -- www.bitxmap.com

I should also add that using a 2N7002 rather than a 2N2222 would be worthy of a trial; that's what the popular ND6T design uses. Once ready to destroy the new V5 kit just received, I plan to build

I was going to order mine from India and use DHL, but I did not see the DHL option - where is it in the HF Signals website? I ended up paying about $20 more to order from GigaParts - $69 instead of

As soon as I finish this cup of coffee, I'm headed out to the UPS warehouse about 12 miles from here to pick up my new SIGLENT SSA3021x spectrum analyzer that my wife got me. I got notification from