开云体育

Forgot to answer your question. Yes anything using the RA8875 controller draws too much current. The 3.3V output from any of the Teensy MPU's is a MAX 250ma and the other chips on the board pull

I'm looking at larger displays (would like to avoid the major surgery for a 5", but would like a bigger display than the 2.8"), and I'm seeing a 4.3" TFT with resistive touchscreen, 4-wire SPI, and

Super helpful! By "finicky soldering," I meant specifically the soldering of the SiS5351. :D Can't wait to get started!

Well, the BITeensio isn't offered with the finicky soldering done. That would make it too expensive for most people. Yes, there is a remote control program available on the website that interfaces to

Aloha Jim, I received my kit (realized after I ordered it that I intended to order the next step up, with the fiddly bits of soldering already done, but I'll get help locally and it will be fine), and

SOLD

Please try the following: power on the radio while keeping the function button pressed this will restore the original "factory" settings. 73 Allard PE1NWL

Maybe post a few pix of the display & your ubitx v3??

If you are getting a waterfall with PSK31 signals displayed, I would be a bit puzzled.? Perhaps start with digipan as it tends to be easy to get working.? Make sure you know what a PSK31 signal

Here is the link: http://www.hfsignals.com/index.php/ubitx-tuneup/

Hi Chuck, As per the instructions it is not a voltage set but a current set. Look it up to confirm my memory that it is 100 mA for each transistor with no signal applied. 73, Bill KU8H -- bark less -

Hi all, I have to replace the finals and the bias adjust pots, what is the voltage set for on the 510 finals ? thanks chuck

I have and this works, thanks.? Should've been first on my list. When connected to my computer, I can read the display just fine.? All the raduino contacts appear to be properly fitted and there is

Glad you like it and Thanks for being my guinea pig <insert evil laugh>

/g/BITX20/topic/27834998?p=Created,,,20,1,0,0 /g/BITX20/topic/28049653#61619

I had my BITX40 spread out on a breadboard and powered up and operating. I wanted to take a photo of it with my iphone. As I moved the iphone to within about 18 inches of the BITX40 to take a picture

Ubitx V4 updated to CEC 1.08? PSK 31 will not decode in any PSK software? Fldigi,HRD or Digipan? I can decode CW in all 3 ok. I tried using Easy Digi with or without No difference in either. ? I

My uBITX has always been a little deaf (couldn't figure out why) so I built a RX front-end addition. Also wanted AGC so it became an amplifier followed by an attenuator. As with prior AGC / RF Gain

Mine has a diode where that is supposed to be.

I now understand I should swap out the relays but there is still part of my original question. I asked if there are any mods that need to be done to the current version you are shipping Is there a