开云体育

SOLD

Please try the following: power on the radio while keeping the function button pressed this will restore the original "factory" settings. 73 Allard PE1NWL

Maybe post a few pix of the display & your ubitx v3??

If you are getting a waterfall with PSK31 signals displayed, I would be a bit puzzled.? Perhaps start with digipan as it tends to be easy to get working.? Make sure you know what a PSK31 signal

Here is the link: http://www.hfsignals.com/index.php/ubitx-tuneup/

Hi Chuck, As per the instructions it is not a voltage set but a current set. Look it up to confirm my memory that it is 100 mA for each transistor with no signal applied. 73, Bill KU8H -- bark less -

Hi all, I have to replace the finals and the bias adjust pots, what is the voltage set for on the 510 finals ? thanks chuck

I have and this works, thanks.? Should've been first on my list. When connected to my computer, I can read the display just fine.? All the raduino contacts appear to be properly fitted and there is

Glad you like it and Thanks for being my guinea pig <insert evil laugh>

/g/BITX20/topic/27834998?p=Created,,,20,1,0,0 /g/BITX20/topic/28049653#61619

I had my BITX40 spread out on a breadboard and powered up and operating. I wanted to take a photo of it with my iphone. As I moved the iphone to within about 18 inches of the BITX40 to take a picture

Ubitx V4 updated to CEC 1.08? PSK 31 will not decode in any PSK software? Fldigi,HRD or Digipan? I can decode CW in all 3 ok. I tried using Easy Digi with or without No difference in either. ? I

My uBITX has always been a little deaf (couldn't figure out why) so I built a RX front-end addition. Also wanted AGC so it became an amplifier followed by an attenuator. As with prior AGC / RF Gain

Mine has a diode where that is supposed to be.

I now understand I should swap out the relays but there is still part of my original question. I asked if there are any mods that need to be done to the current version you are shipping Is there a

1) When we followed Tune up instructions for adjustment of the Power Amplifier Bias - All currents measure ok by instructions up until speaking into microphone, the current did not increase as per

When I had the same problem changing the encoder fixed it. Good luck!

Hi I concur with Jack about capacitive screens being less precise. I have a tablet with capacitive screen it it some times jumps to conclusions with out me touching it. I have also noticed it doesn't

For Sale: first run uBITX. Never powered up. Including lots and lots of extras: USB extension cable to have a socket on the outside of your case. 3D printed knobs - pot & encoder and LCD bezel (all in

try to clear the memory locations before loading stock firmware, once you had used cec firmware.. thereis one .ino that clears eeprom locations. regards sarma vu3zmv