开云体育

With standard gain settings I would not suggest it stock on FT8 which is a 50% run time. With a small fan blowing over the stock heatsinks the output transistors get hot on FT8 after 8 cycles I have

Happens in every country. However if you feel hurt and you are convinced they did not act properly you may have the possibility to report this to other departments so they may see to investigate

Warren discussed this in detail. TX IMD are quite bad, however it does not sound bad at all. Keep in mind it splatters if you shout into the mike. I will try the VOGAD add on, at least it should

Sometimes the police can be a bunch of ignorant buttwipes. One sheriffs deputy tried to claim that we HAD to give a refund, when we had a sign that clearly stated no refunds. he did not really know

I notice that nobody mentions the best way to check an SSB outgoing signal. You need a good two tone audio signal generator. Along with a wide band scope, check that you see a good sine wave pattern.

Nice to point out that existing pot. I suggest leaving it there, lift one leg and try a second pot in series on front or rear panel to trim the output power. Just he careful to route coax around the

I have had that same issue and would recommend 7180. Evan AC9TU

You could add relays and pots to adjust power across bands.? I'm thinking about using the current system for 'max out' and a second layer for 'max 5W out' when feeding my WA2EBY.

Thanks for the feedback from all of you. Allison, I wonder if that pot could be brought out to the front panel using some silver/teflon coax for the round trip without creating too many isues? Or is

There is a strong broadcast signal on 7275 which is putting a fairly strong carrier on 7277.? Not good for weak signal work.?? Seems to me the calling frequency should be moved to someplace below

I had the same problem. (Well, at least I thought I did, turns out it was a PICNIC error). Put the radio in CW mode, and find an AM station. Hope that helps. Dave - AI6K

Hi Simon, I don't think this is true.? What is true with homebrew, is that the device doesn't not have to be tested by the FCC; the spectral requirements are still the same, but it is up the the user

Seem to hear that self build, home brew is more relax under fcc laws than mass production factroy machine, to allow progress in test, training, education, etc., in principle. Still want to emit a as

If i buy a new one, is the good relay come with present version? Or it is consider a user mod, that i need to buy my own good relay 73 Simon

Rf pickup on adc can be observe by loading an adc read arduino program, on serial monitor. Use handheld 2m tx with ant near the push button and wiring 73 Simon [email protected]> wrote:

Garbage in, garbage out. MRM

As is kit without mod, How much power output is ubtx and btx40, for 100 percent continuous digimode? Should i use a larger heat sink? Can output higher with higher voltage and bigger heatsink, for 100

Connect multiple thick ground wire from pcb , said rf plug, to multiple point of case, for each piece of casing metal plates. Contact between metal plate is not fully reliable, in strict sense. 73

Charles French, just back down RV1 on the bitx.? or better yet start at 0 (FYI its counter-clockwise to max not min as its backward) and run it up till the 1208 gives full power using CW.? Since the

So, for current version that if i buy today, is it basically true that the overall story is 1. btx40 is just meeting fcc spec, i believe is 50dBc for lower freq, 2. Ubtx is just a bit short, but not