开云体育

Want to use a Baofeng mic on my BitX40 but have not been able to find sockets for the cabinet. Anyone know of where I could get them? Thanks, Scot WB7AVU

OMG. acidentally crept in perhaps . could you please share a photo please, !!!!! regards sarma vu3zmv

I OPENED UP MY uBITX? AND TOOK A LOOK AT THE S1535A BOARD. THE CRYSTAL HAS 20.0 STAMPED ON IT INSTEAD OF 25.0 MHZ? --- This email has been checked for viruses by AVG. https://www.avg.com

I OPENED MY RADIO TO INSPECT THE CRYSTAL ON THE S15351A BOARD. THE NUMBERS 20.0 IS STAMPED ON THE CASE INSTEAD OF 25.0? COULD THIS BE MY TROUBLE WITH THE FREQUENCY READOUT OF 1 KHZ LOW . W4NFR ---

I used this to line the interior of my plastic case.? I overlapped the tape and soldered sections together at the overlap.

so, there is one spur fix that is now consistently working for me. among rhe solutions, i was looking for one that would be easy to apply. first, the distortion in the 45 mhz amp is creating harmonic

Yes...sorry for wrong spelling

I believe you meant hamskey web Ian Lee web site.

S meter using lm358 as sensor is very simple. One more sensor version is using another Arduino. For more info refer hamsky web. wrote:

Hi Doug For illustartion pupose it was left there Yes I know it can be taken out by inserting a pin into the notch 73 Pop VU2POP Sent: Thursday, November 08, 2018 8:13 PM To: [email protected] Subject:

Here is a list of links for ch340 drivers for both the Mac and Windows. /g/BITX20/message/51600 If you do decide you want to run the CEC uBITX Memory Manager on a Mac this link may

Regarding the shielded enclosures, yup, most good radios are enclosed in metal cases. Receiver only is far less fussy. I was looking at a number of possible cases for my BITX, and decided on a BUD

Joe I am contemplating same thing. Note the? nd6t website shows 2 different agc designs, and note the link to adding an RF gain control. This is one candidate location for the mosfet attenuator,?

Bruce I would like the details also. I am on QRZ or Olson339 at Comcast dot net 73 Art N2AJO

Hi Jack: I'll send you the details directly since this thread is off-topic.? Anyone else who is interested feel free to drop me a line. 73s, Bruce KC1FSZ

The crystal is not "bad"? http://www.hamskey.com/2018/05/frequency-adjustment-of-ubitx-si5351.html

it may interest the group, last year wes and bob drove me through the erstwhile Tektronix campus in Portland. Wes told me how tek pushed the technology envelope. they invented many things from storage

i must have a bad 25 mhz crystal? i will try to get closer to 25 mhz and see if that does the trick. --- This email has been checked for viruses by AVG. https://www.avg.com

Being 1khz off is not "normal". It needs master calibration adjusted,? NOT BFO CALIBRATION. Mine is hardly ever 10 cycles off.

THE BOX ABOVE THE uBITX IS MY HB DIGITAL WATT METER AND SWR BRIDGE. THANKS FOR THE REPLY. W4NFR