开云体育

For GUI v3 please try this . ( https://www.mediafire.com/folder/mmu6ua683lk93/Nextion-Screen-1097#g9pqdwt6i6u5s ) https://www.mediafire.com/folder/mmu6ua683lk93/Nextion-Screen-1097#g9pqdwt6i6u5s (

Here is an example of one of the little swr indicators where you just dim the diode https://qrpguys.com/tuning-indicator I’ve used that kind of a circuit as well as the two torrid system others

If you look at the schematic of your tuner, there is probably one or two resistors in a voltage divider chain that you could parallel something with to increase the voltage that gets to the meter.

When I'm googling for something home brewed, I use the term DIY. Such as DIY screwdriver antenna. I get the most hits that way. Vince.

Stay away from their 1/8" phone plugs. I had the tip of one fall off inside a jack. Problem was the jack was on the back of my Kenwood TS430 and I had to pull the back panel to get the jack out to get

Here are some code snippets from a project I did. It calculates SWR from the voltages read from analog pins A6 and A7. It does a number of other things, so here are the basic pieces of code for SWR

*Hello everyone and thank you for the work. I will want to know if someone has made the firmware for Nextion 3.5 with CEC 1.097. Thank you Michel*

Correct, no meter provided. A DVM is sufficient. Or could go into analog pin A7 (with an analog switch to select forward/reverse) of the Nano.? Perhaps both A6 and A7, use D0,D1 for the keyer if you

Allison, the instructions are pretty terse.? Looks like the meter/meters does/do not come with it.? How does it work?? Use a DMM to measure forward and reverse voltages and do the math in my

Bill, I guess you are right.? I ought to be able to do some experiments before we leave to get a sense for how the MFJ performs at low power.? If I can understand what readings correspond to 2:1, I

this will save a lot of people a lot of time. -- 72 and God bless KD4EPG

I agree, John. I just found this. I think it ought to be on the website, readily available to all. I wish I had had it weeks ago.. -- 72 and God bless KD4EPG

I have modified the CEC Nextion screen for my 3.2" 3.2 Enhanced HMI https://drive.google.com/open?id=1BwHgaScL0lGLMs9l_hC2UMzTafX_nKDS 3.2 Basic HMI

I'd? like to thank Jack and Tom for their reply as once I loaded the CH340 driver, I was able to upload 1.28. Jim W6yxy

UPDATE I found the low receive was due to a bad NANO. I have a spare Raduino board and put it in and it worked, replaced the NANO on the other Raduino and it worked. Problem now is? I have no XMIT

-- Allen/KA1KIX/Uncle/Dad/Friend

The new discussion group has been formed. [email protected] Three persons have volunteered to be moderators (Gilles, Dennis, and Jim). I will make them moderators just as soon as they have

Your results are disappointing as I'd suspected they would be. The amplifier chain seems ot struggle to make power and the quality of the power is poor. What also is suspect is the two IF stage 12 and