开云体育

Use a program called WinRAR

how do we open this rar file, looks like what i'm looking for.? can't find where the led leads connect to the board, and which 3 leads the mic connector uses.? been away for a while, but having fun

Ladies and gents. Lets play nice. 73 Ken VA3ABN

I am not engaging. I will answer any questions from any quarter. But this has turned into a troll farm simply to assert control over a narrative. I think the real story is very clear for any

Bummer that is was not as claimed. Its not like doing it right is hard or costs much. Some examples here: https://m0ukd.com/homebrew/baluns-and-ununs/91-magnetic-longwire-balun-unun/

You first.? Do it right this time. Your methodology is faulty and the results are corrupt. I've already made that exact error before, you want to stick by it its? not something to be proud of.

Cheers all thanks for the quick response!?

Hello Daniel I have pulled the blue and green wires from the plug and soldered the 4k7 resistor to the raduino board, and it still does the same thing. It does this when I don't have 12v to radio -

Hi Dan, I googled to see what other values are quoted for the pull-up. The input impedance is claimed to be 100 megohms. The pull-ups, when activated, are 20k ohms to 50k ohms according to the Arduino

Yep I wasn't independently thinking, but when Allison mentioned putting a resistor across the terminals like when used as a dummy load, I knew what she was talking about. With a 470 ohm resistor my

Show your data and methodology.

I have and disproved your methods, logic and resulting data. Allison

I just installed an LM380 amplifier instead. Why an old '380? Because they are rated for 22 volts and I had a bunch. Found one with less than 5ma. quiescent current. Very quiet and just the right

Allison i am not going to engage further in these semantic battles. I have produced data, discussion, and transparent methodologies. You have produced words. Your agenda does not seem to be in pursuit

Well done Kees and thanks. I agree the moment has come to call "Time". Having the gerbers available will enable others to have boards produced if required, including future group buys. 73 Bill, VK7MX

Make sure all the wires actaully connect at both ends.? specifically the black brown and yellow. There are a few other things it could be but one step at a time.? The fact ther eis some change

The rf path you normalised is the inner conductor and the inner shield.? Doesn't stop or measure current flowing on the outer side of the shield.? ?Explain to me how the RF on the outside of the

Your did not understand or you'd stop and fix your error.? Using? 2 meters of wire and calling that common at RF is about as faulty as one can get.?? Repeating myself.? The RF circuit for the

Warren doing it wrong and calling it good..... "Oh stop.... please!"? To borrow your own line. It is not the case for testing the transformer.? ? Your trying to make a case that is invalid. Allison

Oh stop.... please! I tested the transformers in an environment in which they would be used. The cables were normalized out of the equation by connecting them to each other before normalizing the