开云体育

Thanks, I understand that the OP has a lot of? ADE-1-24.? Thus I decided to remove my earlier comment. regards ?sarma ?vu3zmv

I would guess that the install went badly. I think that there is a program called Windows Update manager that you should look at and see ifit will allow you to uninstall the update. I also think that

Tnx Jerry for this valuable explanation in plain English. I learnt a lot from it. Hope this topic could become a question in the FCC exam if not included yet (I don't remember I have ever seen it).

Great job Malcolm. Where did you buy the tuning knob? thanks Carlo IZ4SJP

Do you have a photo on it installed so I can get the orientation? Thnx

Many thanks for that Jerry! Live and learn, yes solely cw, so filters will be the way to go. SSB for me would be a bonus that I probably wouldn't use ! The main source of irritation for me is the very

Guys, Sorry if I ask a silly question. Do I have to switch Arduino nano to mega2560 if I use the Nextion display? If it’s not the case, what is your incentive to switch them?, I’m just curious.

The receiver spec's how big of a signal goes in to give a desired result. The microphone spec's how big of a signal goes out given a specific input sound level. So the first gets a smaller number if

Awesome bezels from this site, http://compfranon.uk/product/bezel-for-nextion-3-5-lcd-touch-display/ Very professional looking.? Stephanus

I was using my ubitx v4 with a 12v 3a power brick all was going well. then it powered off and back on on its own and now when I transmit I get a high powe rcarrier and squeel but no audio .

Michel, thanks for sharing this.? I will check this out and make changes. Have you seen any other problems that should be addressed. Thanks again for sharing this issue. kn4ud -- Allen ?Merrell

Agreed - How *can* you "counterfeit" Open Source products??

Hi Razvan, The pins of interest are pin 2 and 5. Since they belong to the other transformer, you might expect different LO leakage at higher frequencies. Other than that, you will get a lot of bang

Theoretically the mixer (transformers, diodes) should be balanced and whether you ground pin 2 or pin 5 makes no difference, especially within the specified working range (0.5-500MHz). However,

Hello all Fine job Juddie, congratulations! 73 Saulo PY7EG 2018-07-15 14:40 GMT-03:00 WD8WV <juddie.d.burgess@...>:

Hello Mike and Bo, Thank’s for your responds, I agree with Mike, I need the sketch sources, for some modifications. eg: pins assignations, specifics functions for myself and other choices. I can

Then it will definitely need some changes to the sketch!?? The i2c pins are different for a start. I'm not sure what else would need modifying. Mike -- Mike Woods mhwoods@...

Thank you Allen, I was able to remove a number of switches from my original case after changing over to the Nextion screen. I also changed some colors using the Nextion editor, just for my preference!

Thanks Jerry, I had always thought the opposite, the lower the more sensitive just like sensitivity in a receiver. So, I was wrong. What about sensitivity in headphones and speakers?

But they are not counterfeit as the hardware and software is open source. Sent: 17 July 2018 04:20 To: [email protected] Subject: Re: [BITX20] Windows Serial Port Problem Counterfeit boards bear marks