开云体育

Great job Malcolm. Where did you buy the tuning knob? thanks Carlo IZ4SJP

Do you have a photo on it installed so I can get the orientation? Thnx

Many thanks for that Jerry! Live and learn, yes solely cw, so filters will be the way to go. SSB for me would be a bonus that I probably wouldn't use ! The main source of irritation for me is the very

Guys, Sorry if I ask a silly question. Do I have to switch Arduino nano to mega2560 if I use the Nextion display? If it’s not the case, what is your incentive to switch them?, I’m just curious.

The receiver spec's how big of a signal goes in to give a desired result. The microphone spec's how big of a signal goes out given a specific input sound level. So the first gets a smaller number if

Awesome bezels from this site, http://compfranon.uk/product/bezel-for-nextion-3-5-lcd-touch-display/ Very professional looking.? Stephanus

I was using my ubitx v4 with a 12v 3a power brick all was going well. then it powered off and back on on its own and now when I transmit I get a high powe rcarrier and squeel but no audio .

Michel, thanks for sharing this.? I will check this out and make changes. Have you seen any other problems that should be addressed. Thanks again for sharing this issue. kn4ud -- Allen ?Merrell

Agreed - How *can* you "counterfeit" Open Source products??

Hi Razvan, The pins of interest are pin 2 and 5. Since they belong to the other transformer, you might expect different LO leakage at higher frequencies. Other than that, you will get a lot of bang

Theoretically the mixer (transformers, diodes) should be balanced and whether you ground pin 2 or pin 5 makes no difference, especially within the specified working range (0.5-500MHz). However,

Hello all Fine job Juddie, congratulations! 73 Saulo PY7EG 2018-07-15 14:40 GMT-03:00 WD8WV <juddie.d.burgess@...>:

Hello Mike and Bo, Thank’s for your responds, I agree with Mike, I need the sketch sources, for some modifications. eg: pins assignations, specifics functions for myself and other choices. I can

Then it will definitely need some changes to the sketch!?? The i2c pins are different for a start. I'm not sure what else would need modifying. Mike -- Mike Woods mhwoods@...

Thank you Allen, I was able to remove a number of switches from my original case after changing over to the Nextion screen. I also changed some colors using the Nextion editor, just for my preference!

Thanks Jerry, I had always thought the opposite, the lower the more sensitive just like sensitivity in a receiver. So, I was wrong. What about sensitivity in headphones and speakers?

But they are not counterfeit as the hardware and software is open source. Sent: 17 July 2018 04:20 To: [email protected] Subject: Re: [BITX20] Windows Serial Port Problem Counterfeit boards bear marks

I agree that taking advantage of the CAT interface and using a second computer, that is HDMI capable, is probably the most practical approach.? However: One big advantage of the Arduino computers is

//Draw Smeter if(pm.cp.val!=-1) { jSMeter.val=pm.cp.val*12 <—— 10 pm.cp.val=-1

It depends. I use i, j, and index quite often in my code and find nothing wrong with it because those variables are almost always used for the same purpose and are rarely the source of program bugs.