开云体育

Have any pricing done on them yet?

My 2A supply will not work the ?BITX on 80M.? The supply trips out on overcurrent.? It works well on 40M and above.

0.1 mfd across the power leads at the power supply and again at the uBITX power connector. It could be that RF is modulating the 12V power lead and that causing RF in the power supply regulator.

Seems like the problem is coming from the 5 volt lead. I am hesitant to try more than 10uF from it to ground due to the charging surge. It already has 2uF when the AGC is connected. What about some

You misunderstand me, Ralph. I don't WANT it to act the same. If I wanted that, I'd just run it directly from the jump box. But I don't want it to run away in RF, as at that level it can damage my

Ah, ubitx.net says “5 Amps should suffice”. // hiro, JJ1FXF 2018/06/30 2:33、hirosmb JAZZ <hirosmb@...>のメール:

Those two daughter boards especially with those long wires are a sure way of inviting RF pickup especially being so near the LPFs relays. It could be that the boards are picking RF directly by being

IC. https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.com%2Fulk%2Fitm%2F122586871489 Is the one like above OK? Thanks in advance, Ralph. // hiro, JJ1FXF 2018/06/30 2:19、Ralph

Make sure the ground is a healthy healthy healthy connection as well, either a chassis or some pretty thick wires and lots of them, arrange so they all connect at some point called single point

That's apart from Gordon's suggestion

Try RG58 for the supply.

You may just get by with a 2 amp supply, but I would go with at least one rated for 3 or 4 amps. It is always to have a few more amps than needed so the supply runs cool.

Sprinkle 0.1 ufd capacitors from supply lines to ground. They’re cheap, and they’re great!

The issue discussed in the 'RFI from uBitx TX after AGC and other mods installed' thread appears to be caused by RF getting into the 12v supply and from there into the 5v supply that feeds the AGC

The photo is of a 5" touch screen (resistive) display (7" is an option) and the processor is the Teensy 3.6. Al (AC8GY) and I are working to finish the JackAl board for everything. I posted a

Thanks, R.E. Yes, I read about the power supply in different thread. If I am correct, ubitx works properly with 12V 2A power supply, right? Let me at first carefully find the one at AKIHABARA where

I haven't experienced any noise problems.? I still must shorten some wires and think about a final mounting arrangement. -- Jon Titus, KZ1G Herriman, UT USA

Very nice, Jack.? Have you described your setup?? I'm interested in the type of display and processor board, and the software. -- Jon Titus, KZ1G Herriman, UT USA

I used a plastic cutting board and some pieces of single sided copper clad board mounted with "L" brackets as a temporary "enclosure" to mount the board and controls ?so that I can play with mods and

Arv, Appreciated for your comments and pointers of details. Certainly let me try some mods you advised after I set up my ubitx as it is. I am not a hardware guy and so need a little more time to