开云体育

do you connect this amp to the speaker wires from the uBitx or do you take the audio from before the audio amp on the uBitx board? thanks ?Stephanus

I have a 5 watt dummy load consisting of 5-1 watt carbon resistors, gold band, soldered into a PL-259 connector circa 1970's. It was given to me from an elderly ham, now SK. He learned I was starting

Here are a number of hardware devices that are applicable to uBITX operator interface designs: ? http://paladinsemi.com/ ( http://Here%20are a number of hardware devices that are applicable to uBITX

This is what I bought for $29 plus shipping,

Tim. That is the marker M 7.049 , its very low in level and not seen. Raj

Merci Je vais essayer . Ce n est pas grave si cela ne fonctionne pas. Je ne suis pas habitué au lignes de commande. J utiliserai IDE Raduino lorsque on aura le fichier source. De toutes fa?on j ai

Mike, Well, thank you for that information about the TTP229. The code I found did the job for an HDSDR controller project that was eventually abandoned even although it worked as planned. The

Alan, Sorry for the relay info. I see what you are getting to now. Do you have a "pop fix" modification in place (any flavor)? Rowland: What happens if you unplug the AGC board (everything else still

This is not quite correct. This sketch is a hack that would work but the TTP229 is a true i2c device. See the following use case that deploys the wire library:

Michel, If you have the Arduino IDE, there is a command line utility built into the package. it is called "AVRDude" and can be executed from a terminal window. Here is the command line that works with

Hi, can someone explain how to wire the ssm2167 into the mic circuit on the ubitx please?? Thanks Carl.

Hi there, If I'm not too late, could you put me down for one of each of the anti click and agc kits please. Payment has been sent. Regards, Les M0BSI.

Thanks Nick. I will try that fix for the audio amp noise burst by muting the LM386 via pin7. Seems that there are two problems here. One is the audio noise burst which your fix addresses. The other is

forgot the picture......

Kees, i'm in the middle of a similar project.? 2 x AD8307's. The bridge uses a balun core. PCB is 50x50mm.?? No Nano etc. There is a neat SWR meter here using the AD8307's but with a Teensy.

“ It would? have to pass down to 28.0 for CW” but not needed for cw so maybe easier to just switch it out below 28.3

Kees, Also, both your implementation and my implementation use the single ADC in the Arduino to read?the forward and reverse channels one at a time There will be a significant delay between readings.

Hello i tried hexuploader and it does not work with nano arduino while it works with arduino uno. he puts as a message: avrdude: stk500v2_ReceiveMessage (): timeout avrdude: stk500v2_ReceiveMessage

/g/BITX20/wiki/UBitx-PTT-POP-Fix

Regarding code for your Tandem Match SWR meter, below is where my code was parked a couple months ago. It may or may not be stuff you can use. I haven't made time yet to fully implement it, though I'm