开云体育

I used the info in this thread to wire up mine.? Works great for me! /g/BITX20/topic/16775725#47078

Question: ?will the S-meter feature in v1.08 work with the stock LCD? Mike N6CMY

Yes.

I just wondered, as we're using the BuyDisplay.com displays which also offload the processing to the display. We're using the SPI interface with the touch screen feature as well. Are the Nextion users

I used a 7/16 drill for the mini USB, it clears no problem, and 5/64 for the mounting screws.

This means stock heat sink supplied is just enough for ft8?

The ft8 has an overall cycle of 50%.i use it with the standard issue heatsink. - f

I am not using the irf510 in my ubitx, but rather the irf630. My heatsink is an old pentium 4 sink cut in half with both fets bolted to it through mica insulators and thermal grease. On FT8 the

What are heat sink requirements of ubitx for ft8 and other digital modes?. Just binding irf510 on back panel of casing(like in sunils case) is enough to withstand heavy duty cycle demanded by ft8?

anyone pls comment

I'm only speaking for the CEC firmware, I don't know if the factory firmware has the same behavior. I've noticed the calibration and the "VFO" "interact". Probably a bug. It you do a calibration and

How much down are the spurs? Are they predictable (translated)? Even with an unmodified Ubitx?

Hi Farhan, you know I have been a seller on amazon for over 6 yrs selling data storage systems, HDD Docks etc. their commission & other charges are too high and they even penalize the seller if the

The CEC code has a lot of very good options. The options do make it a bit more of a challenge to work through. ?There may be more "adjustments" made elsewhere in the code. There are a number of if

Try this. You might like the actual book better anyway. *Getting Started with Arduino, *available at O’Reilly <http://shop.oreilly.com/product/0636920029267.do>, Adafruit

Well, there's definitely and issue there...Now I could get my uBitX to Transmit on the exact Dial freq changing those lines in the code. but...The CW RX BFO isn't getting recalled or applied or

You must have a reasonable grasp of English (and Arduino C) to have got this far - I'd suggest read it all again, and be accurate in your communications (both here and to the rig!). 73 Dex ZL2DEX

WOW effect!

Nice.? What tool did you use to cut the hole to mount it to the box? Thanks! Mike KK7ER

Allison Am I correct in that all of the following amateur bands are affected? 18.068 - 18.168 MHz 21.000 - 21.450 MHz 24.89 - 24.99 MHz Something around 26-27 MHz (varies by region) 28.000 - 30.000