开云体育

Why not make a unique open source project like uBitx for a 2M transverter?? From what i've read a tranceiver it's too expensive or complex to build but transverters seems more accessible.

I have changed just R63 so now it is 24 ohm (I added 2 ordinary 100ohms resistors in parallel) as suggested. I confirm it increases the average power to the right level given the stock mic element.

You only used 4 2n5209s correct? The results looks good.? ?Have to see how that would look on the spec analyzer. It may be very good. Allison

I haven't been following all the uBitX threads closely, but I believe someone out there has developed software with CAT control. If that is indeed the case, using that can fix your problem. For FT-8

In the IDE 'Tools/Board" menu it identifies as "STM32F103C series".; "Variant: STM32F103CB (20K ram, 128K flash)";? "Upload Method: STM32Duino bootloader:; "Port: COM3 MapleMini". Device Manager

Many thanks for the help guys (it's much appreciated :o). I'll have to do some testing on mine, as I didn't think I was seeing a 'curve' in the power out, rather something more linear, with high

The inductor winding (40T) could be tweaked slightly taking turns little closer o to increase 5.76 to become 6uH. please try with little patience you would succeed. Regards MVS Sarma

I am an old dart like you! Its the price we pay for having done a few things in our lives. This is interesting: My Raduino is fine. It was the rotary encoder that was preventing tuning and entering

another typo, I used 2N5109's. glenn vk3pe

I decided to install wine for macOS and give running uBITX_Manager a try, with wine. My test showed it works with possibly a few minor issues. So, here is how to install wine: First I needed to

typo, the last '2M' should be 6M.

Allison, Nick, all, This might be of interest I managed to find a couple of 2N5019’s and put them into my proto driver board (ie Q90 to the push-pull FET driver stage) The other stages have

I changed but i get great value on the 80m and 40m but 20m and 10m is very low 20m is 2 watt and 10m is less than 1 watt

Thank you very much for your cooperation and helping

Thank you very much and sorry about what happened but it's mistake

You using maple boot loader? -- Allen ?Merrell

Dual gate mosfets are still a way to go as preamp.? But we are talking a Bitx on two and there are no others spots for them. There are various amp modules most have drive requirements of 50mW or more

You must be an old fart like me. Nowadays the 'pretty girls' are our grandkids. ? I built an analog VFO in the 70's, doing all kinds of things to get freq stability with temp changes, etc. My 2nd

Farhan, Sorry, I just realised it was the wrong post. Here is the correct 45Mhz filter response (the scale was wrong on the first post): /g/BITX20/message/45700 73, John (VK2ETA)

Hi Dr William, How is your radio performing with the mpsh10 and rd16hff1 ? 73.