开云体育

https://www.mouser.com/ProductDetail/Chip-Quik/SMD16?qs=sGAEpiMZZMuzEnlwMwYUNqj7l%252blB9zgl5x1fRR9IUxQ%3d Way too expensive for this application; but, awesome stuff. jgaffke@...>

You didn't specify input into what. For input into my computer from the radio I find the volume pot on the radio is sensitive enough and just keep an eye on the audio level meter on WSJT-X. For input

I would like to have one of each boards also. thanks Stephanus Nell K6NG

I am using a stereo headphone jack. I just ordered a few TDA2822M chips from Amazon, they should be here soon, so I'll update when I get them. Thanks Evan [email protected]> wrote:

Hi Jeff, Look here for the software and hardware mods needed for USB. https://github.com/amunters/bitx40 Allard did a tremendous job documenting all the steps needed. Take a look, it is not that

I should have those too.? One of each (pop, agc). Let us know when to send money, and where. Allison

Never has been a "no Raduino" version in the past. Though you could probably sell the Raduino easily enough in this forum. I'd keep it as a spare. Or hack it into a Sweeperino. ?

Any tips on setting the audio input levels? ?I've found it is critical.

I had occasion to snip out out my Nano recently, wasn't as easy as I expected. See second paragraph of post? ?/g/BITX20/message/50027 A minor edit to that post: <? Then remove

made a tool for my Ungar iron, about 1" long piece of Copper? with 1/4-20 thread to hook to the element. Apply to one, clear holes. Apply to other side repeat. The I use the hot air to loosen the

Clipping leads, heat a pad and either blow 'right hard'(southern saying) or poke with a tapered punch. Works great. I found a nice electric desoldering tool on eBay but they didn't say that 220VAC was

Thinking of getting a second one for experimenting with the 2560/touch screen. Any savings or source of one without the Raduino? Bo W4GHV '54

Change ECM & try...

Rudolf Very good summery. This might be in your document, but there are also variants of the Blue Pill on EBay that have "Arduino Compatible" bootloaders already installed. Some say they have "Maple

Hi thanks for the reply ... the software change is probably beyond me, the Raduino software is preinstalled. Is there a way I can alter the cuicuit hardware and install a switch to change modes??

Thanks, Jack. Had no idea about battery. I'll have to look it up. I thought i'd just have to load firmware after installation [email protected]> wrote:

I use chipquick and wick

I started in the 70's and saved my beer money to get more memory chips for my TRS-80. ?

I won't say it is the best, but what worked for me two times. Due to my fault while modifying the ubitx I had to replace the nano board. I used one of the hot air rework stations that can be bought

I haven't done any adjustments or calibration yet. ?Been too excited getting it going. I need to Google and get the info to do them. Thinking an external audio level meter is needed. (my o'scope is