开云体育

Hi my ubitx was posted via India mail on the 12th April and received today on the 14th just 2 working days and no customs charges brilliant now the fun begins.

Mine has FCI and Pl1 then TDA2822M on it, have had it on RX for quite some time. Phil - G7BZD wrote:

WX is the marking. Ideally cut the 12V track and feed 9V from a regulator. I use a 78L09 soldered on to the board as a hear sink. You can use a 7809 or 7808 on the chassis and run a wire. Raj

Do we know what the markings are on the faulty IC's Phil - G7BZD

Nice PAUL, Don't just increase volume much and don't immediately use ear / headphones. *Many buyers, are perhaps not using the experiences of others.* The do irrelevenat and then only relaise after

On Mon, Mar 5, 2018 at 07:46 pm, Jerry Gaffke wrote: > > Set bias for 100ma of drain current on each IRF510 using RV2 and RV3 and > then leave it be. > That 100ma shouldn't change much even if you

I can agree. The vast amount of help received Seems to have got me sorted with rf at the dummy load. Just now to get it on air for a signal report. -- MM ? WXT GQRP - # 15057

Thanks Nick. MUCH easier on the eyes… Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner

PDF Version

Here we go folks: 73

Hi This is kind of an Ashhar question.... What's to become of all those fast-failing TDA2822 chips? Has the vendor offered any compensation?? The main reason I'm asking is -- I've been in a number

Hi All, attached is an updated user manual for the KD8CEC 1.061 firmware. The updates were to 1. incorporate feedback received on the manual, with some new ??? operating tips,and 2. enhance the

Lawrence, So happens I'have all the mobile manuals and the SSB for radio amateurs since they were printed... Yes its a good circuit, low noise and wide agc range.? HyCas is a variation of that as

The Greater Cincinnati Builders Group is actually doing our Pixie build on the 21st. I'll let the group know how it goes. Jack, W8TEE

I also agree that the Pixie is less than a CPO.? We have done this a couple times at schools we work with.? It's a lot of fun. Garry, AK4NA, is arranging 10 Pixies for the school he supports for

Just got my package? and so glad that the chip now has a socket

Part 3

Part 2

Ge evening Allison. I mentioned it because of the two fets used in cascade at the front end and the use of agc. It's design being nearly 50 years old is a totally different concept. As you said the

It might be the DDS/VFO board we did for the QST article (March, 2015) on the Forty-9er. The only touchy thing about the buck converter was the Phillips head screw that adjusts the voltage which was