开云体育

super starter kit r3

I think I’m getting dumber the older I get but I can’t figure out how to search for specific messages in our Group List. Putting the pound sign in front doesn’t seem to work, and just putting

Anybody remember this from your grandpa's magazine stash ? - f

Which starter kit? Having recommended this kit, figured I might as well get one.? Arrived today: ? ??? ??https://www.amazon.com/Elegoo-Project-Starter-Arduino-Mega2560/dp/B01GEEWIPA Haven't

Vince, Mike, Randy and all Thank you Mikde and Randy. And congratulations on communicating normally with your computer. Vince Version 0.27 is a slightly older version, but it is okay. I will release

Vince Please check the link below. http://www.hamskey.com/2018/03/cat-support-ubitx-firmware-cec-version.html uBITX Manager communicates with uBITX which KD8CEC Version's firmware uploaded. Please

so..used Xloader...loaded v0.27 all good and CAT Functioning ! Thanks Vince n2aie will post pics..been working east coast on 40 SSB..

Ian, thank you for the reply. Yes, please send your configuration file.? That would be most helpful.? My email address is: davidaker@.... I'm looking forward seeing your new release when it

David 1. If the reception frequency of CW is different from the transmission frequency, it can be easily solved by uBITX Manager. In uBITX Manager, if 'Shift Display Frequenc on CWL and CWU Mode'

today I got the book and the starter kit, so far I have learned to save, compile and edit the blink sketch.

http://www.qsl.net/cx8abf/hrd.htm Randy

Vince Sorry you got an Internal Server Error.? These occur periodically when the server runs out of memory (i.e. whe 6000 BITX20 list members go to the website all at the same time!).? They clear

Final update: I restored the resistor values to their original sate and instead added an amp stage (half of Bitx bidirectional amp) and that gave me a much stronger (+15 dB) and more stable DDS/VFO

that was Dr. Lees v.1.04 Vince

Ok. I've checked out your site before... Just was gun shy to ensure i had the farhan load.. So your steps are fine .. reloaded Farhan no problem. all good then did IanLee's version...uploaded fine now

went directly.. I'll check it out Thanks Vince

Mike, Getting this on your link. * Internal Server Error * The server encountered an internal error or misconfiguration and was unable to complete your

Vince The KD8CEC Memory Manager requires mods to the stock firmware or installation of Ian's firmware to work. Check out the guide at: http://ubitx.net/how-to-load-up-a-sketch-on-your-raduino/? and

also current load is v2.0 that came with the rig vince

I didn't mention, I'm just using the Arduino IDE not the Ian Lee memory manager which i cant seem to get it to read the nano (in windows) vince