开云体育

Could work, first time this was suggested. An extra wire, the Raduino regulator would get hotter. ?

Title. Fake news. Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner – Operator Villa Grand Piton -

Where did this info come from? RF Parts shows these in stock. I just purchased both the RD16HHF1 and RD15HVF1 in quantity from RF parts and received them in 2 days. Mitsubishi still shows these on

Actually, the closest available MOSET to the IRF510 is the IRF512, which is the same device, only it is rated for a drain voltage of 100v. It goes by other numbers as well. There are many devices

When you current limit the PA you are doing the same thing that happens when you overdrive a linear amp and cause flat-topping, i.e. the PA is driven out of its linear range. That causes spurious

Jerry has the group discussed pulling 5v from somewhere else like use the 5v that powers the Raduino? Maybe temporarily until they can get a regulator and or new WX chip? Joe KD2NFC

Jerry, A lucid and easy to follow explanation! Thank you! tim ab0wr "Jerry Gaffke via Groups.Io" <jgaffke@...> wrote:

I used to watch my grandfather repair tube TV’s with this one.

I used the one foot long cable and it fit perfectly in the Hammond Case as you can see. I ordered it on Amazon just because they can deliver in one hour, or next day depending on how quickly you want

Looks great Tim, I agree with you, it's a nice rig for anyone. Joel N6ALT

Finally found time to finish up my ubitx. I am *impressed*. Tuning works fine. Audio sounds fine. Calibration is dead on. BFO is dead on. Using a 16ohm speaker the audio is plenty loud and the ws

Go for Quansheng uv-r50.? Far far better than

Thanks Jerry I did see the other fix to add LM7805 regulator plus 1 .1uF cap.? I will order 2073D if someone has tried it as well.

The 862D+ is going for about $50-$55 right now. I have two of them and they both work great. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

I have a small butane torch (harbor freight) that comes just before the propane torch. Vince.

I wish they (Chinese ebay sellers) were a little easier to communicate with. The generally send this pre-packaged reply which says " We do not care about that detail" ! There is one, called Alice with

Weller WTCPT Soldering Station ( http://www.eham.net/reviews/detail/4478 )

Me, too. I got: It was about $70 and it's pretty nice for the money. It has an iron, but also hot air. I've only used it a few times, as I use my old iron for thru-hole stuff. Jack, W8TEE

Thanks everyone for your suggestions and help. As soon as I get back the house I will do some more research as recommended on the iron and other parts. I am currently waiting by my mail box for DHL

I purchased a hot air rework / iron station for around 70$ I can do smd work with it