开云体育

We will end up converting this uBITX in to an SDR by the end of the day...

Ordered Mine Jan 13th via DHL and no notification yet.... seems like it may be soon!

Set bias for 100ma of drain current on each IRF510 using RV2 and RV3 and then leave it be. That 100ma shouldn't change much even if you were to go from a 12v PA-PWR to 24v.? Adjust power level using

A 15kHz DSP IF will be fantastic .... no need for a separate CW crystal filter, get a notch filter, noise reduction, variable brick wall bandpass, etc. M

Bob: Search this list for your answers. See especially the thread "rv2_messed_up_setting_and_txing_like_mad!!!" This goes into some detail about adjusting the RV pots. john AD5YE

I received my uBiTx about two weeks ago. I experienced some of the same issues that others have reported: 1. I did find that the wiring diagram for the three 3.5mm jacks to be confusing and the

Roflmao! I wasn't going to comment but this guy is right on with this.

On Mon, Mar 5, 2018 at 03:04 pm, Tim Gorman wrote: > > Walter, > > What kind of thermo switch are you using? > > tim ab0wr > > On Sun, 04 Mar 2018 17:56:59 -0800 > "Walter" <W9KJO@...>

Mine was ordered Jan 5th and just got shipment notification today. DHL says it should be here by this Thursday evening. (pending customs, weather, aurora, meteors, etc) I concur with the 60 day mark

Bob Tanks for feed back. I often test with nano only. I sometimes did not make A6 High, so I did not know if CW-Key was being pressed and I had a hard time trying to catch a bug. so I have now

Postage from the US to down here in Oz is now unbelievably expensive compared with what the rates were a few years ago. And we also face the current exchange rate plus the money changers margin. By

I look at it that the Arduino is an "easy" way to get the job done. It doesn't mean it's the best, but things like a Teensy and a Blue Pill can take a bit more time to get working the right way.

I'm going to order mine next month, has it shipped yet?

PH0KKO You can change the BPF filter center frequency by just changing the capacitors, but there is a potential problem. As the capacitance gets higher the filter bandwidth gets narrower. You can

Hi all, I am building the Bitx40 dead bug style. Basically changing the Bitx20 and using a different BPF, VFO frequency and low pass filter. For the BPF I used the design shown on the hfsigs website.

*hey look what just turned up! X60, and lpf and hpf and audio breakouts..*

Exactly 60 days! Mine shipped today! Another 3 to 4 weeks and I can get started on it! LOL! ? 73 KW4SZ Corbett Sent: Monday, March 05, 2018 3:10 PM To: [email protected] Subject: Re: [BITX20]

I received my kit about 15 minutes ago SN 654/2? Ordered Dec 19 shipped India Post Feb 12 to Toronto area Canada. Once I clear my ERC rotator controller I may see what I can do with it.? Have the

I am looking at a few replacements myself as I have the WX version that seems to be prone to blow. Some of the other options NJM2073D-ND NTE7155 or buy another TDA2822 I have not tested any of

Here ya go: http://www.hfsignals.com/index.php/ubitx-circuit-description/ Near the bottom. Right click on it and save it locally so you can enlarge it. It enlarges quite clearly. Vince. --