开云体育

Walter have you tried dire wolf on the Rpi? You would still need to run RMS express on the laptop but you can connect to the RPI as a TNC modem using KISS. That’s how my winlink set up works at the

Simple problem and I am stumped! I wrote some test sketches to test the Analog Pins that are on the 8 Pin molex? called "Controls" on uBit. Well on all 5 Nanos I have here, A6 and A7 don't want to

Fldigi runs on Rpi. Wsjtx also and host of other programs. Joe Kd2nfc Sent from my Ham Radio

Thanks for the pointer in the right direction! I'll give it a go :) -- Ryan Flowers - W7RLF MiscDotGeek.com ( http://miscdotgeek.com ) Multi Band BITX40 ( http://miscdotgeek.com/bitx40-digital-jt65/

Mini.? NOT the kind on your phone; one size up.

What kind of port in on the ubitx a micro usb or mini usb -- 73, W9KJO Walter

Thanks for the release Ian, good job. Joel N6ALT

Wouldn't you have to insulate the jack frame from ground? That would be a return path from either the tip or ring to ground through the headphone transducer.

Didn't have it on long enough to transmit. Turned on, saw the number on the DVM, turned off and said some unrepeatable things. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http

Good thing you didn't transmit, that would have given you something. Something like smoke and flames where Q13 and R141 used to be on your Bitx40. Just in case others decide to replicate your

You are correct, Clark.? This needs to be said loudly to any who might plug a TS connector into TRS jack, much like there are warnings about connecting power supply voltages backwards. A little

Very cool, good job.? Persistence often pays off. Think of it as mostly educational, so time well spent. ? That 160m trace seems to have a strong third harmonic, which makes sense. The 80m low pass

All CAT Support uBITX Firmware CEC Version 1.04 Release, but?There is no major change compared to version 1.03. I released it for people looking for HEX files. *The changes since 1.01 are as

There is no phasing issue with a bridge HAve a look at page 4

B40, nothing. I accidently gave mine 20+ when a regulator shorted in the worst possibly way. No damage done. With that audio chip I'll be using a much better regulator! Although I may replace it

Having the NANO board indicates that your BITX-40 is the later version. Earlier version with analog VFO is identical except for the VFO. _._

Ok.,Philip-my mail is :yu1km1010@... Mni tks....73 de YU1KM/qrp,Miki,Belgrade.

You could just drive both amps in parallel instead of bridge, this would avoid the phasing issue. But connect an amp output to the ring terminal will still burn it out if you plug in a mono plug,

Hello Jerry, My bad, indeed on the probes there is a lttle switch and the one I used yesterday was indeed set to 10x. So the mentioned voltages should indeed be 10 times higher. That would make more

i ordered Jan 5th and got my notice that it shipped today Mar 5th Jim wb4ctx