开云体育

I ordered mine early/mid January and I set my expectation for early March(ish) after reading the lists and seeing the traffic. I'm cool with that, it's clear that the uBITX has caused a LOT of demand

Building SWR bridges is pretty easy for most people here and there are many examples on the internet to follow if you want one. The difficulty with the uBITx in its current form is finding a way to

The project is on the right track. Everything is already in a metal box (cookie), it is already possible to transmit, getting about 12W in 40m. and approximately 7 in 20m. For the other bands I do not

I ordered on Jan 17th. They said 3 weeks before my item ships 2 weeks ago. Yikes, I’m in for the long haul. ?

Get well first then worry about your radio chris [email protected]> wrote:

I just picked up this kit works great stock up to 15W if you have a pic programmer you can flash the SWM3 hex and get it to over 40W. ?I have tested this to 50w with the SWM3 firmware and it works

So there shouldn't be a 10K between the diode and the gate of the fet? There isn't one on the original schematic and there aren't any pads on the circuit boards for one either. tim ab0wr

Ordered on 01 february at moment i don't have notice if rtx was sent. i think there are problems with the orders, this is the answer:"It will take few weeks for the order to be shipped. Tracking

Pop down to my Blog for further details, then come back here and talk about it: http://g1kqh.blogspot.co.uk/ 73 Steve

Good morning Ian, With the CW TX->RX Delay set low 0-140 the extra dit/dah is random, with it set higher it becomes more pronounced. At the default 600, it would give an extra dit/dah after every

new slack channel to be open to more then just bitx (

More follow-up. Voltages are all approximately what is shown in the K7AGE table for the Q13-15 devices, slightly less as I have 11.5v out of a regulator to the main board. I bypassed the regulator and

Ordered Dec 16 via India Post and Royal Mail in UK Dec 16 Receipt from HF Signals Jan 24 notice of shipping in 2-3 days from HF Signals Jan 31 notice of shipping from PayPal Jan 31 Receive item from

They are now processing orders from 12/19, I was notified today. 73 de Olaf

Hi I order 15. december and receive by Indian post Yesterday her in Denmark 73 stig Oz8pz Sendt fra min iPad

Currently, HF Signals is processing orders from around 18 December.?? This suggests a backlog of 6 weeks or more. On the other hand, orders may have tapered off after that date, since the HF

No very helpful for diagnosis unless you spell out pin numbers. Start with the SQUARE PAD as pin 1 and then clockwise 3 5 8 - 9 12 14 16 01-03-05--08 16-14-12--09 The in between pins are not

Jason I have been using my uBITX with no modification at all. I have not found yet a problem with the both settings. Maybe it's a bug I could not think of. CW TX->RX Delay only sets the value so

ok back again. flu decided to give up and leave.?? on receive K1 Pad 12vnext three in line no voltage. other side across from pad ,first three 12 volts. last one in line 0 volts,? k3 no voltage to

On Fri, Feb 9, 2018 at 06:22 pm, Ian Lee wrote: > > CW Speed (5th Menu), - Currently set to 10wpm > CW TX-> RX Delay (5th Extra Menu), - I've tried 0 - 200 and it is every > few dits or dahs, at 600