开云体育

Thank you for the information. Just to be clear, the changes from Mr. Kang have fixed your PA drive level with using the IRF510s? No other changes? Have you checked on 10m? -Rob

Hi, I can confirm that the above fix (Mr. Kang) works :-) Yesterday i changed the value of R65 to 4K7 and the value of R63 to 10 Ohm. I used 1206 components (desolderd from scrap prints). I now

Might try looping lead (leads?) to amp thru a ferrite, or get the split clamp on ones, close to were it goes in the amp? Wrap up in a coil any extra length of the cable.? Makes a common mode

Thank you Release New Version. CW keying on MIC PTT is nice.(Impliments mine onto Ver.1) I'm modified TX HAM BAND ONLY to function:void Check_Transmit(void). It's need Japan Radio reguration. and...

i imagine that Prabha jee Pleace a 01.1uF capacitor on ech channel, at the middle pin of Violume control to ground. It would byepass the RF induced in the speaker connecting cable. Aduio would

all I wanted to do a simple hardware modification, so I early to finished firmware develop. also almost no space left for the programming, I am going to work on fixing bugs. This version of the

external amplispeaker... i heard audio even volume down

Is it external speaker or external amplispeaker? Regards MVS Sarma

160m doublet feed with 450 ohm line.

This issue is from microbitx

I am using external speakers. During Tx, it picks transmitted audio. Any remedies ?

Hey all thought I would post a new element I have been playing with,? had some good audio reports with this one after some testing I have decided to keep it. JLI Electronics (

Hi Everybody, I just uploaded a file which describes a hardware and software modification to the uBITX to interface a resistive keypad.? See kb1oiq_ubitx_keypad.pdf if interested. Enjoy! Thanks,

What are you using for an antenna? Vince.

David Thanks for very important information. that is my mistake. i plan release version 1.0 from version 0.35 with fixed it. Thanks again, David. Ian KD8CEC 2018-02-07 7:49 GMT+09:00 David S via

Thanks guys! Roy WA0YMH

Turned the output down to about 8 Watts and have made 4 contacts on 160 with great reports. Will add a larger heat sink to be safe.

No need to add a library for si5351 support when using Allard's Bitx40 code that is version 1.20 and beyond (including all of the 2.* releases, and Farhan's uBitx code) The si5351 support is compiled

OK guys, my bad on Allards raduino sketch.? after a nap and some diligence i realized i did not have the Pinchange library installed. this is the first time i have ever seen a library installed

I don’t have a spectrum analyzer but I think your right. Without the LPF installed I’m seeing over 20 Watts out on 160m and with it I see 12watts out so a lot of signal outside of the 160m band is