开云体育

After I saw the post and responses I was wondering too.? I ran across this that might help.? If nothing else it helps with doing fast digital writes. Quadrature Encoder too Fast for Arduino (with

Ordered my new uBITX on December 18th just got notification of shipping. ?I ordered via DHL so hopefully not much longer

I had the same thing using amplified computer speakers. When I plugged in a 8 ohm speaker it cleared up. Also the 3.5 mm speaker jack has the tip and ring shorted which doesn't work well for a

Thank's Ian, very good effort. I am running v 0.35 today, but I will upgrade to v 1.0 later on tonight. Cat interface for ,say FlDigi, is a very useful feature. Quite happy and Manager assists a

has anyone played with a joystick for bitx control. my thought is to use the ubiqutous KY-023 analog joystick module. mounted in a single hole. they come threaded shaft and not. 2 10k linear taper

Oh, yes, now I see. I got overly excited there for a moment seeing the 10w on 20m.

Yes, it depends on input Z of the amps.? I remember tube amps.?? I built a big stereo in the 60's, they had Hi Z so low values worked.? I have a great story....... My neighbors had a water heater

Rob, This is a change to the mic amp. It will not fix the low power issue with the PA. Marco - KG5PRT

Mice, I had these experiences that old Inveterted audio electronic telephones instruments called secraphones installed for VIPs close to Radio Transmitters used to misbehave. We immediately used

Thank you for the information. Just to be clear, the changes from Mr. Kang have fixed your PA drive level with using the IRF510s? No other changes? Have you checked on 10m? -Rob

Hi, I can confirm that the above fix (Mr. Kang) works :-) Yesterday i changed the value of R65 to 4K7 and the value of R63 to 10 Ohm. I used 1206 components (desolderd from scrap prints). I now

Might try looping lead (leads?) to amp thru a ferrite, or get the split clamp on ones, close to were it goes in the amp? Wrap up in a coil any extra length of the cable.? Makes a common mode

Thank you Release New Version. CW keying on MIC PTT is nice.(Impliments mine onto Ver.1) I'm modified TX HAM BAND ONLY to function:void Check_Transmit(void). It's need Japan Radio reguration. and...

i imagine that Prabha jee Pleace a 01.1uF capacitor on ech channel, at the middle pin of Violume control to ground. It would byepass the RF induced in the speaker connecting cable. Aduio would

all I wanted to do a simple hardware modification, so I early to finished firmware develop. also almost no space left for the programming, I am going to work on fixing bugs. This version of the

external amplispeaker... i heard audio even volume down

Is it external speaker or external amplispeaker? Regards MVS Sarma

160m doublet feed with 450 ohm line.

This issue is from microbitx

I am using external speakers. During Tx, it picks transmitted audio. Any remedies ?