开云体育

Yes, I know the feeling. I feel like this every morning. - Rich WB2GXM

Hearing Tom VE3THR in Western Ky. Denis, WB8SKP

I ordered mine on Dec 19th once all the pay pal stuff went through. I emailed them direct today and they replied shipping next week. Pretty close to your date.? They also said PayPal would be

Aurelio I will make sure the Raduino designer knows about your problem. Yes, I understand the situation with old eyes and tiny components. Same problem here. Arv _._ sarnese@...>

Hi Gordon, I need a Raduino board.... PayPal invoice me. My shipping address is the same as my billing address. Bernie, KC9SGV Sent from my iPad

Worked Tom (VE3THR) with good signals both ways. Hear Tom working someone else but couldn't hear the other station.? I'll be on again at 7PM.? -- John - WA2FZW

Ian I commend you on your latest software Beta release (v0.30). This worked faultlessly for me, and I loved being able to adjust the step rate (I have it set on 10Hz now). The band stacking

Audio taper is preferred for the volume control, since our ears respond logarithmically, Linear taper works fine, but will seem a bit too touchy and hard to adjust on the low end. The design is for a

?Yes, it is, Cesar, and now you might want to solder in female headers on those open sockets and then you can just PLUG IN a nano rather than soldering in the next one......sorry for the troubles

?Bernie....I think they are so overwhelmed now that it will be months before they get back to offering anything other than just the basic transceiver. Partly for that reason I ended up making a

I wish i had the possibility to buy spare things such as the raduino base board. Unsolder and rake apart the nano is a pain in the neck

I had the same error messages. Found out the mini USB port was broken. The plug was prohibited to be inserted properly by one of the small metal clips on top of the socket. This was bent down into the

Found the center socket in the BNC spread out so it didn't always hit the BNC pin. Jus say'n 73 don

I'm on 7277 & will check 7278 -- John - WA2FZW

Use XLoader and a ready compiled hex file. Look here...(original v2 code is pre-compiled and ready to load) http://radioaficion.com/news/how-to-upgrade-ubitx-firmware/ Nigel.

hi Arv sorry for my bad english i have checked the output of raduino with Digital oscilloscope the frequenzy is wrong e change rapidly the signal voltage output is too low i am sure the raduino don't

Aurelio IZ8EGM The designer of the Raduino does monitor this group, but also has other jobs. He may respond as time allows, or others might step in to help. [image: Inline image 2] By "oscillator

Thanks Jerry ? I deleted the original post. Here are the traces of my original audio output with 40 meter band noise input and after adjusting the BFO for better low frequency response for CW. The

the ic oscillator of raduino doesn't work i have checked it. there is not good signal from it, i would buy a new one (because i don't have the good iron and is it too much little for my eyes) but the

Those of you that have gotten a mail from me you are covered. If you have not gotten a mail from me at this time most if not all kits are spoken for. I am going to build the orders up and finish up