开云体育

Found the center socket in the BNC spread out so it didn't always hit the BNC pin. Jus say'n 73 don

I'm on 7277 & will check 7278 -- John - WA2FZW

Use XLoader and a ready compiled hex file. Look here...(original v2 code is pre-compiled and ready to load) http://radioaficion.com/news/how-to-upgrade-ubitx-firmware/ Nigel.

hi Arv sorry for my bad english i have checked the output of raduino with Digital oscilloscope the frequenzy is wrong e change rapidly the signal voltage output is too low i am sure the raduino don't

Aurelio IZ8EGM The designer of the Raduino does monitor this group, but also has other jobs. He may respond as time allows, or others might step in to help. [image: Inline image 2] By "oscillator

Thanks Jerry ? I deleted the original post. Here are the traces of my original audio output with 40 meter band noise input and after adjusting the BFO for better low frequency response for CW. The

the ic oscillator of raduino doesn't work i have checked it. there is not good signal from it, i would buy a new one (because i don't have the good iron and is it too much little for my eyes) but the

Those of you that have gotten a mail from me you are covered. If you have not gotten a mail from me at this time most if not all kits are spoken for. I am going to build the orders up and finish up

I could not get the blink sketch tonbe uploaded. I also tried the raduino sketch to see that tab thing you mentioned. At first I did not understand that selecting one ino file would just put them all

Aurelio IZ8EGM "raduino didn't work" does not give others much to go on if they are to help you. What part does not work, and what have you already tried? Arv

hi to all i need an help when i have reiceived the bitx40 i found that raduino didn't work, where is possibile to buy a new raduino board without the display? i have sent an email to the website but

I have a 50 k audio taper pot, will that work okay for the uBitx? I also have a 10 k LINEAR taper pot, will that work?? Which is preferred? I am trying to work around the shaft diameter problem

"They will be in alphabetic order on the Tabs."I'm pretty sure that's true, except the file with setup() and loop() is in the first window. Jack, W8TEE To: [email protected] Sent: Sunday, January

No. Put all of the files associated with the project in a single directory. The Arduino IDE will load them automatically and present each of them to you as a Tab above the IDE source code window. They

Yes, nanos are cheap. I will have one tomorrow? regatding the ino files... di they have to be uploaded in sequence? tthanks!

Also interested...Larry - K2ZSD Sent from my Verizon 4G LTE Droid

Your BFO coming out of clk0 of the si5351 needs to be higher in frequency by about 200hz. That's all. From your first plot, the 12mhz crystal filter is doing a fair job, about 2000 hz wide and

Cesar EA3IAV You may have blown your Arduino NANO, or maybe not. In the later picture the red POWER indicator LED is ON, indicating that your NANO is receiving power, but that does not really tell

Would like one too....built if possible...still rough with smd. Steve/NOAA lol

Hi Ian, OK, thank you for the clarification. I suspected that was the case. :o) Mike, Yes when I do add the Chip resistors I'll take a picture and post it. Dave WI6R