开云体育

It was designed with Bit in Mind. I saw someone post the QRP Labs one???? So I thought I would show a better one.? ha.. This looked real good on the SA for return loss. Its perfect for bit, you

On websdr, there is a station about 20-30 miles away. I usually load up websdr and listen to myself on that station. They're having a little problem with 40 now I think, but I can look for another in

Nail varnish? when dry is an insulator as is modelling dope and various other substances. The new suggestion of a thin layer of epoxy will work equally well once the "shorted turns" are separated.

Hi Jack Very interested in the Wattmeter side of this project, do you have further information circuit diagram etc on this item or maybe available as a kit?? Dave G4JBE

What is the purpose of the nail varnish? The reason I may have to rewrap....I'll have to take it out of the case to make sure, but it looks like there may be several strands wrapped on top of each

?Woohoo!!!! Real detective work going on!!! I've never done this, but if you can separate them so that they cease to short, you could put a drop of epoxy 5-minute glue there, and it would perfectly

Mike: Or, how about 150W DL with builtin wattmeter for under $20? This was a build our group did a couple of months ago. The lid is shown here. The resistor network sits in a mineral oil bath. The

Hey, speaking of Dummies.? Here is one I came up with. Its 4 -? 3W resistors.? Has RF tap (0602 Component) either for a resistor or Cap. Shky diode and cap.? Place for LED (0805).? 3 Pin Molex

two disclaimers before this post 1) This may be common knowledge but it is new to me. 2) I am only describing what worked for me.? If you ruin your cables, your oven, your house or your marriage

Don`t go to all the hasle of rewinding the coil, carfully separate the turns (usually spaced anyway) and paint on some clear nail varnish or similar and let it dry, then re-insert in the board. Dave

Joel: Same here!! From a QRP Quarterly article I wrote. The switch Ashhar includes friction-fits in a hole and the wire is old telephone wire. Jack, W8TEE To: [email protected] Sent: Friday, December

I hadn't thought about that. We do it on 2 meters though ha It's looking like the side of the toroid is grounded together at the bandpass. I'll have to take it out of the case to get a better look. I

I’m using a homebrew mic and a Hendricks mic both wired for, Tip=mic, next ring is PTT, bottom ring is gnd. Joel N6ALT

What sort of mic are you using, Joel?

Dennis, I think this depends on how your mic is wired. This is the way mine is wired. Joel N6ALT

BTW these QRP Labs LPFs are great little filters for $5 ... pretty hard to beat !? Michael VE3WMB

When I ordered my 40 I received no confirmation other than the PayPal processing like you. The radio arrived three weeks later. I was uncharacteristically silently patient because of all the nice

Hi Joe, I don’t usually post much on here but I remember seeing a notice on the main page at hfsigs saying that nothing would ship until after Christmas. When you order it also says that they are on

Graham : Your emailed receipt from Paypal is your order confirmation. You will get a subsequent email from Paypal with updated information including a? tracking number from India Post, but only once

This should do it: