开云体育

There was some trouble at dhl bangalore, it has been resolved. Await the shipment details soon. - f

Our local post office refused to handle so many orders, so the gang decided to post all the usa ones through dhl anyway so you guys can get them all before christmas. We didnt do that for europe

Oh, I thought you uploaded another one. The capacitor looks ok but that doesn't mean the connection is good. Load one of the working sketches then put the raduino back in the case like you did to

I included a pic of the sis chip a couple of replies back... right before you asked about just plugging it into usb and computer

what pic? Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/ http://www.metalworkingfun.com

There is a small preset between the two predrivers that maybe used for this purpose. - f

Do those two capacitors look bad to you? I didn't notice that before, but where the solder should be looks cratered in that pic

The USB will not fit into the case attached. I have to do the sketch, remove the USB, then plug the raduino into the LCD.

How about if you unplug everything but the USB and computer? What does it say then? Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

Here is the picture of the Sis chip

When you get to actually transmitting RF make sure you are Xmitting into either a good dummy load (preferred) or antenna you have matched for low SWR to the frequency you are transmitting on. You

Farhan's sketch does not work. Neither does Allards. In addition, the signal on 25 mhz seemed louder than the one on 4800 mhz. I tried Allard's diagnostic sketch and it keeps flashing PTT on and

Got it trying for 4400, 4600, 4800, 4900. Too much interference at 5000 to tell. Going to try Farhan's sketch now

If anyone's interested in putting their BitX in a Pelican case, Harbor Freight is now selling Pelican clones and has the one that's supposed to be the same as the Pelican 1120 for $9.99 with coupon.

Hi all This thread has a couple of topics but this comment about tbe PTT pop only. This mod worked well on my bitx 40. ?/g/BITX20/wiki/AudioMute Unfortunately it will require some

Brave enough to retry Farhan's sketch? Or maybe first try something around 4.800-5.000 MHz. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

Hi Allard san I will wire PTT sense ( A0 black wire) I am a?beginer for Arduino. I do not understand?what? mean??"This sketch version requires the library "PinChangeInterrupt" (

Ok guys.... something interesting happened and I'm not sure WHY. I got the 26mhz tone. I changed the sketch to 7200 and got the tone on 7202.20. So, then I changed it to 7.075 and could hear it on

Mine came via DHL though I did not order carrier service. I just assumed that Ashar and the Elves were adding a bit of Seasons Spirit for the early batch to get here ahead of Christmas. At any rate,

Was wondering if I could adjust the rf out from 10 to 5 Watts. ?I have an amp I would like to use but the amps max power in is 5 Watts. Can I adjust the drive to lower the rf out? Art - N2AJO