开云体育

Bill, have you checked your PayPal transaction for a tracking number? The information should get updated, once the package ships.? Karl Heinz - K5KHK

I see someone had ordered on the 9th and received already, I also ordered on the 9th and have not received the kit or any word from DHL.

I was looking at this to switch the antenna between my recently ordered RSP1A and my recently ordered ?BitX: http://www.qrpkits.com/ezseries.html#eztrsw

Thanks Jack, I look forward to receiving it someday. Joel N6ALT

I think most would have the SDR dongle attached to the computer outside the Bitx's enclosure, so they could use the dongle with other antennas for different applications. I was going to run the coax

Ashhar, Sarma, Raj, other? Is it feasible to drive the uBitX PAs at 24V, or is that asking for trouble? Apologies if this has already been covered; please point me to the thread. Thanks, Craig w9ctw

How to use an SDR for an antenna analyzer: https://www.rtl-sdr.com/using-the-airspy-as-a-vector-network-analyzer-for-characterizing-antennas/ And a noise source that's less expensive than the one in

Well done on getting your licence!? I started with the BITX40, it's an amazing bit of kit and was perfect for my budget. I like how well it's supported too and you can go very far adding to the bare

Mornin' Joel: Well, I listened on 80M and things were jumping. I don't have an antenna for 80M so I can't attest to that, but you're going to love this radio. I got the rig as a Beta tester for

I already have the parts to build one of K4EAA / W8TEE’s dummy load and power-to-voltage converters, but this is tempting as an even lower-cost option. What do you all think? Grease and heat sink?

My guess: Some people don't want it, and many will want to do different implementations.? If you search this forum for AGC you'll find lots of ideas for both RX and TX processing.

What was the reason, that AGC has been excluded from final "factory" version of uBITX? There is enough room on PCB and cost of parts is marginal. Roman Bal

Enjoy https://www.youtube.com/watch?v=RBHZFYpQ6nc Fiddler on the roof - If I were a rich man ?

Hello everybody, while checking the ouput-signal of my BITX40, I found some nastygram signals in the frequency spectrum. Interestingly the emission is at the begining and at the end of 40 m Band

Exclent find! [email protected]> wrote:

Hello All, Changing the driver level of the outpus reduce the carrier to +8.5 dBm and spurs too ! The Pi attenuators on mixers should be reduced to 2.5 dB max (390R/12R/390R) 73 de F5RCT

DuWayne, I'll be following your blog to see how it works out.? I still need to build my sig generator from your? plans... -- Dan Reynolds -- KB9JLO <><

Yes, that is the Banggood case.? I ordered four to use for a couple of projects.

How do you find out when/if it shipped?

I have not tried it on 80M, but might try that this weekend. If I do, I'll get back in touch with you. It did come DHL, but I didn't order it. Ashhar sent me a Beta copy, I guess, and I'm writing a