开云体育

Hello everyone. I’m working on my uBitx project, with my own PCB design. The “front-end” is also different from original. The receiver is already working. If it can help someone, I have uploaded

I believe that one was actually meant for the guy that was getting frustrated with his tuning problem and talking about tossing his BitX in the trash. Vince. -- Michigan VHF Corp.

Did not understand you!

RF must be getting into tune voltage pot. I had such a problem when the ground wire of the antenna connector was loose! Raj

Awesome! I tried it as well with some parts that just arrived. I used 1000uF capacitors and 1W 15 ohm resistors in a second order RC filter, very similar to the video. All the noise from my power

Some of the USB cables are only meant for charging, they don't support data transfer.17 Yes, si5351 drive current can make a difference in how well the signal is received. But weird it is so

Just reread my message and before anyone finds my error, I meant to say with versions 1.04 and 1.05 I ensured I was using Etherkit Si5351 2.0.1. This is not needed in V 1.27.1. Gene

OK while waiting for the Pixie, I finally got the USB port working again (bad USB cable, go figure!). So, I started trying different versions of SW to see if I could isolate the volume issue

"6 ft. 8 ft. Bunch, me wana go home" Something like that? -- Mike Hagen, WA6ISP 10917 Bryant Street Yucaipa, Ca. 92399 (909) 918-0058 PayPal ID "MotDog@..." Mike@...

''Daylight come and me wanna me Bitx'' Lol

I'm still experimenting, but I may reverse my "lead length shouldn't matter much". Let's just say it's a good thing I have spare IRF510's. Although Jerry if my initial experiment was successful, I may

Thanks to everyone for the pointers...much appreciated. Will pay close attention to all suggestions.?? 73, Paul ZS2OE

Haha, I pasted the wrong link in my post.? Sorry about that! Can't wait to hear how this works out!

The thread for this board is actually here (there was another thread dealing with mic emphasis which this module doesn't do): /g/BITX20/topic/6374017#34387 The board can be found

I purchased some discount pots... They came unravelled internally omg. More important than anything is the learning experience. I will buy that which you feel is a waste of your time ...gladly pay for

At the bitx40 we built, the BFO frequency varies in the voice signal. I wonder if it is normal or if someone has ever faced this problem as he did it. Thank you!

tally me, banana!!!

Here's what the EQ should roughly look like: http://www.apple.com/uk/itunes/podcasts/images/podcaststips_improvespokenword20101108.jpg

FWIW, here's the thread that had this little board: /g/BITX20/topic/6393762 Also, Simon did a neat little mod simulation for some helpful

Just turn your soldering tip parallel to the length of the SMD.? One iron tip will heat both pads, flip the part off. Adding solder helps. The crappy "earth friendly solder" flows a lot better when