开云体育

And the LPF's a lump in your antenna feed. No bandswitches.

I looked around some on the interwebs, not impressed by the ssb6.1 Be aware that you are buying exciter and ?vfo and linear and lpf's separately. And that instructions are pretty much non-existent.

Bruce, I believe the howl is not related to the issue of the carrier burst. The howl is probably caused by oscillations of the LM386. Not by audio feedback from the speaker to the mic. The pop from

It means you are measuring from one end pin to the other end pin of R136. The third pin in the middle is best seen from the back of the board. Measuring from the middle pin to ground should be 0 ohms

Allard, I loaded sketch 1.26 today and noticed no change to the carrier burst problem. In fact, it might have been a bit worse if anything. I previously had to change from a speaker-mic to a separate

R136 measures 97ohms regardless of setting...does this mean anything?

If you don't want BITX ebay SSB 6.1 n8iov@...> wrote:

I am also looking for a Multiband hf transceiver kit but with no luck, can anyone out help...

I'm about to buy a bitx20 v3...I would like to know if someone has put 4 line by 20 lcd which has a s-meter in it for the 20 meter...

I'd guess those figures are more like 102ma and 230ma. And that you are not be including the Raduino in those figures. You might look over the rest of these links once you've sorted out the above

Thanks Jerry for correcting my reference for the 100pf mod to the LPF.? I meant no disrespect.? Simple ignorance. -So I have confirmed that my antenna is wired correctly.? COM to bnc shell, board

I am working on a PCB with that alternate part. It is in a 20 Pin package.? It has 8 clocks and one address pin. I have jumpers for the address and the spread spectrum option. I have made one with

Yes, I was wondering about using a needle to get the turns nice and tight. I was also wondering, when they refer to a bifilar winding if you are supposed to make a twisted pair prior to winding on the

The si5351 costs $1. ?Perhaps use one exclusively for first LO, another for second LO and BFO. Stuck at same i2c address, but perhaps an analog switch to select one or the other. Or use one of the

Hello Sarma and Jerry, ? Thank you for your suggestions ! I plan to build something simple and not with tens of BPF and amplifier and so on…. ? During my studies I spent 6 months as training in

Hi Brent, I use #43/61-2403 cores and winding with a small tween wire. I can put 5 windings of 5 turns for one xfrm in my H-Modo Mixer. What I do I use a needle to squize turns into the holes, to make

Thanks John That's what I figured. I tried it with the number 30, and the amp works, but output is low. I'll try to make a different core. The instructions specify 5 bifilar turns on the primary, and

Just got my e-copy of Nuts and Volts for November 2017. Page 36-40 has the Bitx20 project. Sent by me

Thanks!! Warmly yours, Werner Vavken Sent from my iPhone

Brent: Probably not. A viable alternative to the small "pignose" core is a slightly larger one two of the same size mounted back to back, or using four FT37-43 or FT37-61 cores cemented as two pairs