¿ªÔÆÌåÓý

I heard Bill N2CQR and a couple others. I called CQ but got no responses (that I could hear). John KC9OJV

If you are running Allard's latest code, frequency should be reasonably stable. If it's not stable, you should probably address it rather than hide it. Though once that's cleaned up, the additional

Hi Graham, I got stung by DHL when I ordered an AirSpy SDR receiver shipped by them rather than China mail -? that added ?50 to the cost! My BITX arrived very quickly via India post and no claim for

I have the same bad experience with DHL here in Sweden. I will never use term again. With India post there was no problem, fast and no extras.. SM6ERS / Ingvar

Add a cap to ground at the raduino end of the tuning pot wire if you have not already done so, same 0.1uF as the WireUp instructions say to put at the pot. Allard has made a number of improvements to

I added 0.1 uF caps between pin 7 and ground, +12 and ground and PTT and ground with no improvement to the buzz noise on tx. I put resistors in line of the +12 to the mini board, and found that the

just normal for DHL? I will never use them again

I just successfully integrated a SOTABEAMS Laserbeam DSP Audio filter module into my BITX40.? http://www.sotabeams.co.uk/dual-bandwidth-filter-modules-ssb-cw/ I am using Raduino V 1.20.1 with the

In the Files section of the group. I find the fastest way to locate a recent post is to click on the Uploaded column heading which sorts the posts. The first click starts with the oldest post, a

You always have to pay royal mail money if you have duty to pay its old hat getting things from the USA I always get clobbered for duty no matter who I use to ship my

hi there have been various posts on this subject - the general opinion is DO NOT USE DHL i received my bitx40 via india post and royal mail and did not pay vat but royal mail may have recently

The first bitx I got got hit for ?21 from dhl the next 2 bitx I buy I used India post no duty and got them in 4 days from shipping much quicker than dhl chris G0WFH

Look for a knob for a 1/8" shaft. I think that works. -- John - WA2FZW

I know that many people have been adapting the original on/off volume knob using a drilled out 1/4" standoff or replacing the entire control with something that takes a standard size knob but has

Didn't have that problem here in the US. Just the $10 for DHL shipping. ? -- John - WA2FZW

Hello Graham, not exactly UK, but I had a similar experience receiving the bitx to Italy, just that the added cost (taxes+dhl duties) were almost 40€. I believe that in general, for Europe,

Lots of QSB and QRM, but worked Tom VE3THR and Paul KC8WBK. Heard N2CQR, KC1FSZ and KI4PSR plus a couple of others. Conditions didn't start to improve until about 7:30 or 8pm. AL - VE3RRD

Hi All (in the UK) ? I recently received my BitX40 but was a bit surprised to be charged VAT+DHL fee (of a similar amount) for handling the VAT. These added 40% to the total cost (including the

Worked W4OBY (he was not on a BITX, but he HAS one in the works). ? Also worked KN4EAR and? KC8WBK. ?? Also talked to KI4PSR but he was not on his BITX (but he has 4!). ? 73? Bill N2CQR ?

Didn't find any bugs! As a matter of fact, I'm not sure where to find the?software! ? -- John - WA2FZW