开云体育

Excellent advocacy David. Happy to be one of the gang. Doug KA4DXX

I had a lot of fun showing off the BitX40 at this local ham fest at the WCARES table. I did it just as an excited advocate of this fun and quirky little radio, and also to rehearse for presenting it

Another screw thread site https://mdmetric.com/tech/tict.htm 73 Larry

p.s. this is NOT npota or national parks on the air

Going to head out to the park today with the Bitx and my FT-891 will be on 40m psk and ssb as well as 20m ssb and psk if I can setup the laptop. ? ?73 ?? David ??? N8DAH

SolderSmoke Podcast #198 - D-104, HW-8, Juliello, DIFX, Dishal, Baofeng, MAILBAG | | | | | | | | | | | SolderSmoke Podcast #198 - D-104, HW-8, Juliello, DIFX, Dishal,

Thanks Jack 73 Carlos Sent: Saturday, July 29, 2017 12:05 PM To: [email protected] Subject: Re: [BITX20] Finished to build but LCD noise. I'll try to get that done this weekend and then post

As a newbie about to put the radio together I would love a list of hacks all on one sheet and ideally a reference to a document with an explanation or directions. Seems like a file for this could be

I'll try to get that done this weekend and then post it. Jack, W8TEE To: [email protected] Sent: Saturday, July 29, 2017 10:55 AM Subject: Re: [BITX20] Finished to build but LCD noise. Please

Thanks Allard. 73 - LU5DNM Norberto Modanesi San Nicolás

Please Jack, send us the schematic of the modified PSU. 73 Carlos CX8ABF Sent: Saturday, July 29, 2017 11:44 AM To: [email protected] Subject: Re: [BITX20] Finished to build but LCD noise. I had

I had the same noise problem with my TFT display. Because of all the add-on boards that Dennis is working on, I needed additional takeoff points for +/-12V (mainly for BITX40, PA, and Dennis' boards)

http://www.jenningstech.com/ps/jen/prodsearch.cgi?action=capacitors http://www.jenningstech.com/contact/contact1.shtml _._

Thanks Larry! -- John - WA2FZW

http://www.eham.net/ehamforum/smf/index.php?topic=110805.0 Eham.net has some comments that could help 73 Larry

Well, thanks again John for trying to help, but the BSF threaded rods arrived yesterday, and it turns out that that isn't the right answer either. I'm really starting to think Jennings used a

I just got 10 x irf510 from ma components in the UK cost ?7.55 via amazon so fast got them in 24hrs they look the same as fitted in the bitx 40 so I think there good stock

Today the new AD9850 DDS has arrived and now everything is working again as it should. I let the Diodes in series with the AD9850 Vcc supply jumpered, because it really runs "hotter" for me (as

the power supply going to raduino has to be filtered at -close to raduino by say 100uF and 0.1 disc cap or MLC cap. -- Regards Sarma

I've finished the Bitx40 experimental project today. I added the AF-AGC and LM386 POP limitter with raduino v1.20.1 (Thanks Allard). And I also added the DuinoVOX for Digital Mode operation. It's a