开云体育

I used the dymo clear labelling tag looks ok keeps it clean looking.

KA7GPP, Arlington, WA Dan Sent: Monday, June 5, 2017 9:48 PM To: [email protected] Subject: Re: [BITX20] Calling West Coast BITX operators KI7KLT, Camas, WA __ denis

It lights up and tunes. I used one I had in my junk box. I believe it's 8 ohms. I will try to post a pic. Matt Sent from my iPhone 7

Relax and don't give up building! We could use some more details. I'm assuming the radio lights up and tunes? What kind of speaker are you using? Can you post a photo of your build? Jonathan

KK6WCG - Folsom, CA (Near Sacramento) Hi KI6SSI! We're practically neighbors. :)

KI7KLT, Camas, WA __ denis

Jonathan, Bandon, Oregon Thomas W Noel KF7RSF

Thanks Arv The simulator looks interesting...I'll go through the tutorials and see what I can figure out. Paul ZS2OE

Simon, What a boob I am! Of course Canada too. Mexico too while we are at it. So I'll change that to province/state and town. Thanks for replying. Rest of the west coasters, keep 'em coming! We have

K7WXW - CN85, Portland, OR

First time builder here. Got my bitx40 all together. The unit powers up but I hear no static. The instructions say I should hear a low hiss even without it connected to an antenna. I hear nothing.

Should work well enough to bench check it, but I would wait till I got that cap in before transmitting on the air. The cap reduces noise in the tuning voltage detected by the Raduino, without the cap

Hi Simon, VE7SXS, in Terrace, BC, Canada. I am very close to the bottom of the Alaska panhandle.

Pat, definitely a possibility, but I'd first like to see how hfsigs responds to a defective product claim. As I've been troubleshooting this evening, trying different USB cables, etc., I just tried

Mark, The pins on the the nano barely stick thru the top of the nano , you actuality cut the top of the nano, destroying the top on each side. Sounds weird but u need to cut off the top, then you pull

Mark, If you have a sharp pair of diagonal cutters you can get in between the boards to cut the pins and then remove them one by one. I would suggest that instead of trying to remove them all

K7SWF. Lake Havasu, AZ

KI6SSI - El Dorado Hills, CA near Sacramento

Since I cannot edit I should add I am using a 10 turn pot suggested from back in the analog tune days.

Hi fellow bitxers I misplaced my .1uf cap and am assembling slowly my bitx40.. is this comment required for proper operation on tuning knob or is this something that just improves it's usability/user