开云体育

hi i have ordered a dummy load with a voltage monitor point. i will see what i get with that terry

hope I am home for it

Just a reminder to note the time and frequency for Sunday, June 4.? The time has changed from the previous QSO night.

Same sound without antenna.? By tweaking the bfo you mean adding ?the 27pF cap to the board? Peter Parker mod) thanks

OK, I got 3 guys who wanted Raduino Board. It is the board and Nano, no LCD or Spacers. I did move the Regulator and add capacitors and a limiter resistor on the input. It is programmed with 1.13

Unplug the antenna and see the residual noise. If it drop dramatically then it could be local electrical. The speaker is distorting in the video. It will sound better in a box with low tones louder. I

Yup, 30v p-p into a 50 ohm antenna seen on a scope means 2.25 watts peak effective power of an SSB transmission. That 30v p-p is centered on ground, and is the maximum seen when we shout into the

With a waveform showing 30V P-P into a 50 ohm load the PEP would be = = = 2.25 watts Mike K5ESS Sent: Friday, June 02, 2017 5:17 PM To: [email protected] Subject: Re: [BITX20] power measure And he

Guys Someone made a PDF of the instructions I posted a month or so ago but I am on the road and don't have access to it or who made the PDF. I will be home Tuesday and can post it OR whoever did the

I'm in.

Me too! It is the the PCB with Nano programmed latest version. But, no LCD or standoffs includes. So I want to make sure that is understood. $20 shipped to any US buyer. So, I will give priority to

I have recived many pcbs from international sources that were packed and sent as Hans and Noel describe, sometimes taped to the largest sized thin card or heavy paper that will fit in the envelope, to

Now I'm very confused. Who got the board? 73, Richard

Sorry, hit send too early. Total is $20, 24 or 25, your original post was a bit confusing.

It will be in the mail in the morning. Thanks! Send to Richard Kappler 14 Jefferson Ct Fall River, MA, 02720 73, Richard W2KAP

Don't put anything on the envelope, don't know what it's like elsewhere but, Australia Post ignore instructions/directions on envelopes. Recently had a certificate sent through post not only was it

I'll take it. Paypal OK? Dan Dantzler 12645 Sable Drive Burnsville MN 55337 952.894.8669 Cell 612.817.1561

I can, though I'd prefer to pay by PayPal. RichKC8MWG

Ok. Can you send a check? Mike Hagen 10917 Bryant St. Yucaipa, Ca. 92399

I'll take it! Rich KC8MWG