开云体育

Like I said, I am just now seriously thinking about implementing Allard's enhanced functions. As an example I didn't know what you meant about the "analog oscillator" at first, until I looked back and

I would be happy to hold some local stock and then handle orders from Australia and say New Zealand or other Pacific destinations at cost. The Australian Customs declaration is relatively simple and

Stupid iPhone spell checker BITEX Adrian

Ships from US fast. I got one. $18 plus $2 shipping. Mike, WA6IAP http://www.ebay.com/itm/152111349696?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Thanks, Arv and Jerry, both very helpful. My application is to use uBitx as IF for a UHF transverter (and this project is basically a learning exercise for me), so the transmit chain isn't going to

Hi Joe, That's a good cure for the RX thump, but it doesn't deal with the TX spur that is about 60 mS wide. 73, Bob, WB4SON

No it is Metric. The shaft I have on the Non Threaded version is "D" shaped and 6MM. The non threaded bushing is 7MM. This is what to look for, and comes with the

Thanks Jack. That is what my son said when I showed him the link. :-) Back to the search. Bruce, VE1II

That is a great price on the Mega 2560 Pro Mini...better than my quantity 25 price! On the encoder, make sure you buy one with a threaded shaft, otherwise it's almost zero fun mounting them unless you

The mounting nut is a 7 x .75 mm nut which must be very rare and expensive since most of the encoders are shipped without mounting hardware. Most miniature toggle switches use the same size

That is NOT the right Arduino. That is the Nano Pro Mini, which should cost less than $2. Essentially, it's a Nano, but without the convenience of the USB connector, which makes it a PITA to program.

Hi, I think PTT noise is an issue which most everyone if not all have noticed. There are several solutions. I finally decided on a circuit which uses a FET and transistor to cure the problem, I have

Hi again Ken See my reply to the group…you can get these from Aliexpress for around $1 CAD for 2, with free shipping 73 de Charlie GI4FUE Sent: 31 May 2017 21:52 To:

Hi Ken That’s not the correct board…that’s a ATmega 328, not a 2560 Regards Charlie GI4FUE Sent: 31 May 2017 21:48 To: [email protected] Subject: Re: [BITX20] W8TEE TFT/VFO Board

Hi Bruce I got my 2560 from here, very reasonably priced too :)

FWIW, I only program my Arduino's when powered by the USB cable. You need the cable anyway to download the code back to the Arduino. Jack, W8TEE To: [email protected] Sent: Wednesday, May 31, 2017

I'm away from my shack, but I'm pretty sure it's a standard 1/4" shaft and standard nut. Jack, W8TEE To: [email protected] Sent: Wednesday, May 31, 2017 5:31 PM Subject: Re: [BITX20] Encoder

Actually those two sources are not in conflict. ?Both are correct. ?Both talk about the Raduino, which is the small PCB with the mini USB connector (the display, the nano, and the SiLabs oscillator

Thanks! Powering something from 2 sources simultaneously scares me as I already blew up an expensive gimmick that way!

These are good ideas. I'll investigate this further...thanks!! Jack, W8TEE To: [email protected] Sent: Wednesday, May 31, 2017 5:32 PM Subject: Re: [BITX20] #W8TEE Foreign orders Jack, a