开云体育

My goal is to provide a standard sketch that basically works on a standard unmodified BITX40. The original BITX40 concept, as you know, is based on a tuning potentiometer, not on a rotary encoder. A

I have a bit of a problem. I just received my SWR bridge (MFJ-816) and hooked it up to the radio and antenna. When I set it to calibrate, the needle doesn't move at all. I do hear the key up thump on

Jack, I would like 2 boards but would take one so everyone has a chance for one.? Thank you Ron WV7H

Looks like a great project. I would like 2 boards Joe VE1BWV

I would like at least one. k4ia, Buck K3# 101 Honor Roll 8B DXCC EasyWayHamBooks.com

I usually fill the rest in with ESP8266 boards. At $2.59 USD you can't beat it. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/ http://www.metalworkingfun.com

I'll take 2 boards also. P. J. Hicks, N7PXY

I can't find how to e-mail you directly. (I guess everyone else couldn't either..Hi) Put me down for 2 boards when available. TNX, Jack. john AD5YE

I realize that that this is really just asking for icing on the cake - but any chance of a similar version that uses the encoder for tuning?

Jack, I can use two of the TFT/VFO boards when/if available. Thank you for your generous support of the ham community. Dave KF5OCP

Jack… Would you be able to ship to N Ireland, and if so what would the postage be?..If reasonable I would like one Charlie GI4FUE Sent: 26 May 2017 22:10 To: [email protected] Subject: [BITX20] W8TEE

Jack, I would like 2 boards when/if available. Mike K5ESS Sent: Friday, May 26, 2017 4:10 PM To: [email protected] Subject: [BITX20] W8TEE TFT/VFO Board from FDIM talk All: Attached is the manual that

I'm still good for 3 Jack. regards, Richard W2KAP

Jack , I would also like 3 boards if possible, should there be an extra I would take 4, this is going to be fun! 73 de Seth - W8FG [email protected]> wrote:

I didn't seem to get any documentation with mine. So I had to make do by going to the website while I was building and I also have some friends in IRC on the ##rtlsdr channel Sent from my iPhone

Jack your manual is outstanding.? I look forward to your post with ordering information for the board.? Now I just need to figure out $4.80 worth of something I need from Tayda to make minimum when

Jack, I need 3 v/r Fred W4JLE Sent: Friday, May 26, 2017 17:10 To: [email protected] Subject: [BITX20] W8TEE TFT/VFO Board from FDIM talk All: Attached is the manual that will go with the TFT/VFO PCB

Happy Bitx'ing Sent from my iPhone

Thank you! Now why didn't I see that when I went there the other day? I remember everything else about the page... Thanks! Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

http://www.hfsigs.com/bitx40v3_wireup.html ( http://www.hfsigs.com/bitx40v3_wireup.html ) http://www.hfsigs.com/bitx40v3_circuit.html