开云体育

William, Great! that tells me the ADE-1ask is not a fake! Now I eagerly await further test results from you! Raj, vu2zap

Raj, 1-6 - 0 ohms 2-5 - .216v in both direction 3-4 - 0 ohms W4WHL wrote:

Yes, I have killed two of them one ones my fault when one of the input wires brushed the 12v line and the other I blamed on static as well. That's why I took the time to put a socket so I could remove

A 10T pot for tuning is not required, the beauty of the Rauino is the way it tunes like a shuttle knob on a commercial rig. A poor mans shuttle by Farhan, brilliant idea I must say. A 10T pot is

I was late to the party last night but called CQ a bit but no response. Sunday 01:00 UTC 7195 sounds good to me. AA4PG Pat

Lol silly me I did have the plug on backwards... fixed and no change. I had swapped the tuning and volume pot and plugged it in upside down. VFO? You mean the DDS? Two pin frequency output from the

Sunday 01:00 UTC sounds like a good time Are we going to try on 7.195 again +- based on open freq and qrm. wrote:

William, Please check the continuity of your ADE-1ASK again. 1-6 - 0 2-5 - Diode check both polarity should be same reading 3-4 - 0 My guess is continuity between these pins but not between

We are apparently lucky with not so much static , being in tropical countries. of course i had few PIC16F628Athat failed. but never adapted anti-static measures. Better I learn from your

Reprogramming didn't help unfortunately - It's really blown. I know these are sensitive devices and I always take ESD precautions. Nevertheless it became damaged somehow. I never used this input

let him re program and try . wrote:

Is it correct to say that A6 is PTT in the V1.08 sketch , So it should go high when ptt is pressed ? 73 luc ON2AAV

Yes, two others here in KC area have lost inputs A6 or A7 due to static. I think soldering to wire while still connected to the pin is the reason but I’m not sure. New Nano always cured the

Maybe add another button, dedicated to save. ?I use a single button on my Arduino sig-gen to access menus, held in structs-? quite intuitive, but maybe outside the scope of the Raduino .... -- 73

While I was experimenting with digital inputs, I couldn't get pin A6 working. It always reads a "LOW" regardless of the actual input level. The other pins work as expected. I may have blown the

Sure if that device is NOT faulty. wrote: -- Regards Sarma

Very cool! I wonder if a opto-isolator out of a junked computer power supply would work... S

Gian, the placement shown by Mr. Sunil ( as if on solder side) appears OK as an image. datasheet can be checked i7swx@...> wrote: -- Regards Sarma

Hi William and all, Ithis is a strange problem certainly. I have been following your problem only recently so my comment maybe already reorted. Sorry. Would it be possible to have a sket of the

we can perhaps remove the dc feed path and try coupling thro capacitor. I shall make a sketch and send , you can try that i shall upload soon lee.hemmingsen@...> wrote: