开云体育

I messed up and erased my program and have a blank screen can some one help me setup my program so I can bring my radio back to life again. Trying to locate the files in the group but can't find them.

Increase the VFO drive level. Raj

Let us try to feed both 12V & ground to the raduino, thro a noise suppressing toroidal choke with 10uF caps on either side close to the readuino pcb. I suppose it should help sarma vu3zmv --

I seem to have less birdies with a high side vfo at 19 MHz but I feel like I lost some sensitivity. How about the bfo, does anyone know if it should be driven more than 2ma? Guess I can test this

I'm pretty sure that a "virgin" Nano's EEPROM has each memory cell set to 255. The EEPROM is unaffected by an IDE upload, unless the program changes the EEPROM memory. Jack, W8TEE To:

Where is everybody?

I just tested this. I still had the birdie at 4ma, but it wasn't as loud as 2. 6 and 8ma were much louder than 2 or 4. 73, Ben KE0KKM

Came too late for the party! At 0045 UTC heard a ragchew on 7195 KHz.Dropped down to 7193 KHz only to hear another ragchew. ?QTH: Greenwood, Maine ANT: Home made 40 Meter inverted-V wire dipole @ 39

I guess it's over. It's just two guys rag chewing now. Not QRP. I heard my neighbor W5OU calling CQ too.

Dang conditions were horrible. I heard Gordon W5OU but he could not hear me. Not sure if he was trying for the net or passing by. I pulled up the sdr in NJ and heard KM4OUS as well but that's

This is KG5KYJ in Oklahoma City, I copy N5YAV Darwin Phillips Corinth, MS for relay, RST 45. Net control in Florida, barely audible, not quite intelligible. Everyone else too weak to make out so

I am listening, and I have been calling for the last 20 minutes, but nothing yet!

listening thru webssr still waiting on my bitx to come. where is the net controller located?

I like the idea - I'm listening right now (0011 UTC) and I don't hear anything. I'm in the Reno, NV area, running an OCF 40m dipole at about 25 ft., and an IC-718. Propagation is pretty bad right now,

Should the SI5351 drive be 8ma. As far as I understand from several sources, diodes need to be driven hard. 73 Ken VA3ABN

We are on 7.195MHZ Join us for The BitX 40 Meter Net

Terry, yes I did all that too and it cured the clicks then. But now, when I use the latest library v2.0.3 the clicks are back again. So the obvious things don't seem to work anymore with the latest

I'll try to be on next week. ?Unfortunately I'll have to miss tonight.

As has been discussed in several earlier threads, many of us suffer from an extremely strong birdie at 7199 kHz. Today, while experimenting with the VFO drive strength, I had a surprising

I took a 50 volt 2200 uf electrolytic capacitor and stuck it between the + and - lines feeding the dds. Right at the connector near the board. ? Killed all the clicks. 73 Terry