开云体育

Hi everyone. I was approved to join this group. I have a Bitx-40 XCVR. I have connected all the components to the board. I turn it on and can tune around. The Rx and Tx both work. But there is a tone

Worth experimenting with the speaker so I found out. I have an ex-Yaesu FT290 1W 8ohm speaker sat on top of the Bitx shipping box, sounded tinny, so I sat it on top of a cardboard tube, sounds really

Your choice of a speaker for your BITX40 can really make a difference to the receive audio quality. I had been using a small 2-1/4 inch speaker (you can see it to the right of the circuit board in the

It's a great rig. I got in on the first run before the kickstarter.? The only downside, for some people, is the requirement for a PC. There aren't any stand-alone ADC/DAC/DSP boards available that I

Hi The FT-817 guys have been down this path. Google around to find information. Here is one http://hamshop.cz/data/items/208_76.pdf Randy, K7AGE

What's this about and what did I miss? Might be a good one to attach to the original email. Jack, W8TEE To: [email protected] Sent: Sunday, February 19, 2017 1:17 AM Subject: Re: [BITX20] bitx output

ND6T had a nice informative post about a month before: ??http://bitxhacks.blogspot.in/2017/01/nd6ts-suppression-of-pesky-2nd-harmonic.html (

Or this one: http://bitxhacks.blogspot.com/2017/01/nd6ts-suppression-of-pesky-2nd-harmonic.html??de ND6T

You can inject a few millamps into the modulator at the center tap. - f

How do I go about unbalancing the mixer to produce a carrier? I know that R106 balances the mixer for no carrier. So I assume a small value resistor to unbalance it. 73 Ken VA3ABN

I have a RS-HFIQ running with a 60 dollar windows 10 tablet and 2 external USB sound cards. It works very nicely but no 160 meters.? Mike WA3O

I need information about the core of the transformer T4. There are 9 trifilar turns 0.4 mm wire on core unknow for me. thank you Tom

In his note it is stated to use a cap with a suitable voltage rating. What would that rating be? Thanks Steve kb1chu

Yes I know that R136 is used to control the drive to the PA, and I have already increased it. I do get the normal amount of output power (7W). It's just that I believe that especially for QRP

Is it a Problem with the BFO circuit ? .. Ide have a look here .. Marc 'Gw0wvl' ... Sent from Yahoo Mail on Android On Sat, 18 Feb 2017 at 21:21, Mark Underkofler<mark@...> wrote: I

I just wired up a cheap CB microphone, I'm using a Sadelta Bravo Plus ..I ?bought it as it was cheap and it's been in my box of Bits for sometime, I knew it would come in handy though ?:-) Marc

Hello Allard , I have the same experience and therefore I am thinking about building the PA0FRI RF speech processor for the Bitx40. Go to http://www.pa0fri.com/ Select: "MISC " And then select: "

fabulous stuff! - f vu3vrl@...> wrote:

Adi RameshSent from Yahoo Mail on Android

use what you have. if it blows up. write about it. - f johnlinux77@...> wrote: