开云体育

Hans, Can we not have SUB GROUPS here like BITX40 VFO BITX40 Raduino BITX40 Box BITX20 etc.. Just a thought, I have not tried it on my groups but seems worth looking info! 73 Raj

Ricardo, I can't specifically tell you. You will have to first add the varacters and then see what range you are getting and then you can message me for further ideas. First add parallel varacters and

Hi John At the top of the browser window there are three buttons. One has "Topics View". One has "#HashTags". The rightermost one has a little icon that looks like magnifying glass. This is the SEARCH

Hi! ?Just my couple of bucks worth here - if my everdepleting memory serves me right, the MKARS80 is a relative of the BITX in all its iterations. ? The MKARS clicks continuously and I haven't found

FB, Ronnie. A genuine BOURNS 10k 10-turn pot with all the trimmings for $US8.00. That's a coup! john AD5YE

I think it was mentioned before that it is ~6-10 uH. If one is to increase the frequency span, it cannot be done by changing the inductance alone, unless one increases it by adding more turns. This is

One of the better features of the Yahoo Group was the ability to search the entire message base by topic, or even by contributor. I have not found that to be the case here. Is there a general message

Messages 21347 and 21366 would seem to point to this as being a layout and/or wiring problem. The mcu will produce RF noise. They all do. The trick is finding the right combination to minimize or

hi do you mean ?to reduce turn number in L4 by how much turn? what is the inductance value for the L4 nominal? Sent from Yahoo Mail on Android On Fri, 3 Feb, 2017 at 12:27, Raj

I have the clicks. Very loud. I run straight from a battery. I have not attempted to remedy the problem yet. Too many other things going on right now. Mark K3MRK Sent: Thursday, February 02, 2017 9:36

Change the varactor to one that has higher capacitance tune ratio or Alternatively, add an MV209 or 2109 in parallel with the one on the PCB The tuning range will increase. You may need to tweak the

No schema included in my kit but it is the same as posted with ?hfsigs web minus the raduino. Sent from Yahoo Mail on Android

Sure to that, too! ?:>) Jack, W8TEE To: [email protected] Sent: Thursday, February 2, 2017 10:46 PM Subject: Re: [BITX20] Nano Sketch Size I think he means "Use" and to incorporate them into the main

I think he means "Use" and to incorporate them into the main sketch. "pull", do you mean remove? I was just trying to show a simple way of grabbing a few more bytes if someone needs them.

The old Si351 library used only two arguments to the function. The latest library uses three arguments. Download and install the new library and close/restart the IDE. Jack, W8TEE To: [email protected]

Sure. By "pull", do you mean remove? I was just trying to show a simple way of grabbing a few more bytes if someone needs them. Jack, W8TEE To: [email protected] Sent: Thursday, February 2, 2017 9:16

Thanks, Joel. How about others with the clicking? What kind of power supply and what is the voltage? Does the clicking happen on a battery? Some seem to minimize the issue by filtering the dc around

Rob, Thanks for the info. I am an “Arduino Dummy” but I do know basically what you are talking about. I have a friend who can help with the programming. It guess it’s time for me to get educated

Hi Marco, I'm using a Alinco Linear 40 amp power supply at 13.8V. I have used batteries and other supply's with no clicks. Joel KB6QVI

Probably wrong SI5351 library installed -- Ion VA3NOI