开云体育

They go by a few names. Try Molex .01? 2.54mm connectors on ebay to check Rob

I used the 1.81 installer and that installed all drivers and even the CH340 driver. So I have the CH340 driver installed, but it still does not work. I will just wait for my spare Nano and try if

Can anyone give me a link to a source for buying the 2 and 3-pin connectors used for the hook-up wires? A searchable name for the part would be fine. I am new to building and just don't know what to

* Hi Farhan, I have the same problem but I have low signal on the TX, about 450 mV only then should I increase the emitter resitor? Thank you. Jorge PY2PVT _._* 2017-01-31 2:44 GMT-02:00 Ashhar

As I stated in a previous post - ALLELECTRONICS.COM has 1/8" shaft knobs and 1/4" shaft knobs for $1 each. I ordered real nice matching knobs with RED inlays. They have brass sleeves and set screws.

Thanks Raj, Rig relays are working. ?Both PWR and display had bad ground while PA PWR had good ground. Chuck

tnx rob!

I've added the zip of the CH341? Win 7 driver to the "BitX40 Sketch using new SI5351 Library v2" folder in the files section. Rob

I think 1.8.1 IDE has the 340 driver now as an option during install Rob

The clicks are actually caused by the the time the PLL takes to resettle to a new frequency. It might make sense to disable the output before making the frequency change, wait for a few milliseconds

Most of the time, the arduino trouble are just about having a bad driver. On my laptop, the arduino programmer works with just one of the three laptops. I really don't know why. It would be nice if

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* Audio S Meter Circuit.pdf *Uploaded By:* George

As requested in the files section as pdf. If I update the doc I will update the pdf too. Rob G4NQX

Hmmm no, I was incorrect and in fact it works ok as is. One press adds +R? for rit. Double tap changes vfo A to B. Rob

Could you save it as a pdf also? PDF format is more accessible, and safer. thanks Joe W3TTT wrote:

Hi Pez, I will test the setup later but for now : In the pushbutton routine the first statement as i see it will always evaluate TRUE.? That is to say the pushbutton IS pressed and it's LESS than 3

Great idea Joel. Thanks for that hint. I will do it that way.

I assume you are talking about the Raduino clicking as you tune. I'm not having that problem, but others are. One solution is to bypass both the input and output of the 7805 regulator with some 100nf

If you are going to try to remove the Nano, I would take some flat wire cutters and cut each leg one by one until you have the Nano off the board, then go along and heat the bottom of each leg with

Rob Thanks for starting this document. I thought a FAQ would be helpful, your document is good. Randy, K7AGE