开云体育

<< I have not really been able to find much about where the best place is to put the signal in except for one person who seemed say they put it directly in to the mixer coils via a 0.1uF

Hi Todd, Thanks for the reply, I have been reading the various posts on this this evening and have see lots of people discussing the code (I have written my own code for this) and seen lots of

First thought is to get the dipole off the floor. Unless you are in the 2nd story of a wood building. But generally antennas on the ground don't do much. Does tuning it do anything? Maybe the

Hi there I got my bitx40 v3 and I have hooked up a homemade dipole, i layed it out on the floor.. powered on (did not yet hook up PA).. I get an odd noise: Voice 001_sd.m4a

Ken, I set my Arduino sketch to always start on 7.268.500 so when I turn on the Radio/DDS it always displays that, of course it's only displaying that, but it's really outputting 4.730.100 to the

What is displayed on your DDS? 7.000000 MHZ or 7.001400 MHZ. 73 Ken BITX20@...> wrote:

Thanks DuWayne, Just the info I was looking for. I think I'll build one and give it a try. I already removed the cap between pins 1 and 8 on the 386, so might have to increase gain a bit, we'll

Mark Receiving CW but having broken audio on SSB might be caused by several things but I would start with checking the BFO frequency relative to the crystal filter characteristic. The BFO for USB

I laid out a small circuit board and built it up. It seems to work quite well from the little I have used it. Only thing I noticed was a decrease in total audio level. I compensated for that by

There have been several recent postings on this question. The output of the 5351 can be set at different levels. Do a search of recent conversations on this reflector. 73, Todd

Thanks, I'm aware of the article, what I'm asking is, who has built it and is using everyday, and how do they like it? Does it work good? I've built a lot of audio derived AGCs and some raise the

See this article for AGC - http://bitxhacks.blogspot.com/2016/11/agc-for-bitx.html BITX20@...> wrote:

http://n5ese.com/rfprobe1.htm http://www.qrpkits.com/rfprobe.html BITX20@...> wrote:

Has anybody built and installed farhan's AGC? Does it work well? I think it's high time I install one. Joel KB6QVI

My first version of the Bitx20 is completed and works very well (I just made the receiver part), it was made using through hole components on individual pcbs that plugged together. My next version is

Could anyone in the Bitx20 group know how to send me the Bitx40 kit? After 04 days of purchase no return from Hfsignal. 73, Antonio

Anymore ideas on the low power problem? Only getting milli-watts. Adjustment of the bias pot seems to have no effect on the supply current. A loud HALLO only gets a small flicker on the power

Hi all I want to clarify a few things because there appears to be some confusion here. I have been working with the Si5351A for a long time. The QRP Labs VFO kit http://qrp-labs.com/vfo

Makes sense. My suggestion requires more fiddling. And there's something to be said for leveling the output, considering the various users and their input solutions...the real key is the input level

john, the reason i elected to put the dds into the VFO injection is that, even a very small signal will drive the transistor to limiting. So, all drive levels will be the same out of the VFO