开云体育

Dear Farhan and all the Bitx40 team, Bitx40 #861 arrived this morning, hand delivered to my front door. The Bitx40 is beautifully packed. I will let you know how the testing and integration

I have another, just arrived, Bitx 40. Hooked it up and works as it should, at least for receive. #67, the first, cannot hear a signal generator putting out 0 dBm signal. Running it on a 12 volt

The photo on 'hfsigs' shows PA Transformers for Bitx40 made from toroid cores, but the schematics shows some 6 terminal TV balun binocular or something else - I do not know. Could Farhan or someone

I have a BITX 20m v.3 PA PCB from the ebay shop of Sunil VU3SUA. It has two amplifier stages and two transformers. The description says it can be modified for 40m. But it does not say how. How many

Do you have a nice strong power source? Like all high-gain LM386 circuits, the audio amp is prone to becoming an oscillator when starved of sufficient power. Best, Jeff KK9JEF Sent from my iPhone

You may also be able to drape it over the antenna connector. Try that first without the antenna connected. 73 Ken [BITX20] <BITX20@...> wrote:

Yes I have one. Sent from my iPhone

try http://www.hfsigs.com/ 73 Ken BITX20@...> wrote:

Let's rule out the antenna. Do you have a signal source to fed to the antenna input? It has to be very low strenghth around 50 uvolts (S9). If you feed too strong a signal, you may overload the front

Ken: Thanks. That's the first thing I did having followed this group. I did spread a few out a little but no help. Bill Sent from my iPhone

Hi #952 has arrived safe and sound to the UK in 6 days, very speedy and well packaged. I have nearly finished the home brew Si5351 VFO / BFO so I will be able to power it up soon. 73 Karl G7AFT

Hi Bill Start by checking that the toroid leads are not shorting together. You can use a toothpick to gentle spread them apart. 73 Ken VA3ABN BITX20@...> wrote:

I decided that you guys are having so much fun that I took out #67 to give it a whirl. When powering up I get a very loud buzzing in the ear phones. So, I power down, remove all external

I used the RED wire. I think. . . . BITX20@...> wrote:

Our new batch of Bitx version 3B 3C kits,shall be available by the end of this week on our Ebay Store. We start with 20mt kits followed by the Bitx Version 3B 3C 40mt kits too. Thanks for your

Thanks, It is a good solution. 73.

Well, technically it arrived Friday, but I wasn't able to go to the post office to pick it up until this morning. That is going to be so much fun when I get time to put it together, get an antenna

Did you add it to the red wire or black wire?

The VFO we built for the Forty-9er (March, 2016, QST or see:?DDS VFO Kits)?has buffered output if needed. Two sets of header pins? | | | DDS VFO Kits | | | allow the user to pick off

I was curious when this would come up. I'm sure the quality of the products are good, but I'm not sure how this could be checked without a spectrum analyser etc. Im pretty sure the FCC really isn't