开云体育

After reading the forum, you will find answers to your questions in a lot of information. In the Home column, the last Wiki caption is where helpful information is collected. On the messages page, in

Hello. The update doesn't work, I only get a gray lcd, and nothing on the computer.I got a USB cable with a C type with the station. So I used what I have at home.It asks if there needs to be a

Thanks ! Can't wait to receive my zBitx - then measure up and start designing a rugged case / frame for it. Screen cover / protection, carry handles, strain relief for cables etc.

Here is what else I am seeing (I hope this helps). When I start wsjt-x the zbitx frequency changes to 14.074 which is the default ft8 frequency. I am able to change the zbitx band ONE time with wsjt-x

Yes I am in digi mode. Receive works just fine. The issue is that (a) CAT is not working (b) transmit does not work (c) since cat isn't working (d) can't change band/frequency from wsjt-x. What I

I hope you guys are using digi mode to connect with any other application [email protected]> wrote:

Fldigi hamlib settings don't work either. Leo, AI5II wrote:

My bad, you're right - sorry for confusion. The best advice is to reach out to HF Signals directly at sales@... to get the correct answer Ken, N2VIP

Where did you get that information from?

I went to the buy page and its saying sold out on the sBitx [email protected]> wrote:

The sBitx is apparently offered for purchase right now: https://www.hfsignals.com/index.php/sbitx-v3/ And the zBitx also is apparently still offered for sale right now, but with a 4 week lead

When will the sBitx be back for sale

I should mention I've updated to the latest firmware 1.06/3.051.

I get no rigCtl response in WSJT-X from the zBitx. RigCtl reports the connection was actively refused by the radio. WSJT-X works fine on my sBitx. I've also tried my CTR2-Micro on both radios. Same

That may somewhat defeat the purpose of break-in We had the same trouble with the sbitx until we got the software fix going. After that, it is really really nice for CW. To avoid clicks and thumps I

Until everything is working perfectly, you can still make CW QSOs with a little goodwill. This afternoon/evening, I worked with HS100IARU and 8A100IARU using just the zBitx (without any additional

I think he is out to Zea without a paddle!! But he is very resourceful and I bet he will get back!! Gordon kx4z

Ashhar, are you telling us that you are up the zbitx without a paddle? [email protected]> wrote:

Vince, Thank you for the help. My problem is that I did not associate MACRO with the F key. I just glanced over the page. Dean Sent: Friday, April 4, 2025 12:36 PM To: [email protected] Subject: Re:

It depend on display width. If you tune a CW signal spot on with a 2.5 kHz width it sounds great. Change display width to 6 kHz and the signal is still tuned but the blue column of filter width has