开云体育

Does the distance to the right vary with the sidetone frequency that you have selected?

Thanks, Tristan! That was the issue and now my zBitx seems to work as intended. I wonder if some units got SD cards with earlier system installs on them? 73, Paul, N8HM

I just did this last night, so I can tell you that it's well explained on page 15 of the manual "Editing and creating macros" Note that on some screens you only see the first 7 macros displayed on the

First of all, thank you very much for your support!!! The zBitx is now running! I did the following: 1. Downloaded the image as Jeff described 2. Bought a new 64 GB microSD card 3. Formatted the SD

I noticed that a while ago myself. Mikel Missatge de Nigel Evans M0NDE via groups.io <nigel.m0nde@...> del dia dv., 4 d’abr. 2025 a les 17:51: -- Mikel L. Forcada / Alacant /

Is it just me? I am on 20m 14013 bw300 step 10h the frequency I am listening to I seem to have to put my tuning line on the waterfall some distance to the right of the actual signal I see on the

On the bottom of my sBitx screen in CW mode are pre recorded messages, CQ, call, reply etc. I could never find these messages because I would like to change them. I have found other variables but

Yes, CW feels strange (even after updating: zBitx firmware 1.06, sBitx v3.051). At 18 WPM, iambic A (my usual mode), I sometimes make mistakes I usually do not do, just because the keyer does not pick

Today I successfully tested my HB zBITX with the image shared by HF Signals a few days back. It works well. I tested in without the PICO controller and the display and it worked in the sBITX

1). Wsjt-x only receives data if the Zbitx display is active on? my monitor. 2). Cannot manually start rigctl if I shutdown the zbitx display. Rigctl returns network connection error. 3). With the?

The next update will have to wait until the weekend is out. I am travelling, with the zbitx, but without a paddle. <vincedeon@...> wrote:

I have the same issue. Leo? AI5II

Thanks a lot Vince for your valuable input. 73 Jon, VU2JO <vincedeon@...> wrote:

Ashar, I tried a longer setting as you suggested, values up from 100 to 300 to 500 to 800 to 1000. It does get better as you increase the delay but is still an issue. So I did a simple test, with the

https://www.thingiverse.com/thing:6999275

John's experience matches my own. If I turn down Iambic A or B to 12wpm my error rate drops significantly. I don't straight key much so I won't comment there. I'm really looking forward to the

I have used both flat and button top 18650s in the holder without issue.

100. I'll try a longer setting.

What is your cw delay set to? Try setting it to 600 [email protected]> wrote:

I have WSJTX running nicely on a 2nd monitor on the zbitx except that it is failing to trigger Tx with a hamlib error shown in the terminal window? Can anyone share their working WSJTX radio config