开云体育

./update gives 3.021, not 3.05

I ran into this issue as well. See issue #2. I also am still having a difficulty getting FT8 to use the decode selected by clicking the encoder. Something is definitely better because it is no longer

I wanted to check the 64 bit version without disassembling my sBitx v3. It was possible via changing the boot order. The procedure is quite simple. Just run "raspi-config" utility (in the terminal

Updated RPI and then was able to update zBitx SW. All is well now. Tnx, Tom KT4XN ________________________________ Sent: Saturday, March 29, 2025 8:55 PM To: BITX20@groups.io

Yes. I have backed up and restored from the 32 bit sd card. I just tried it again this morning with the same results.

Dean, I'm just writing to encourage you that I've had the v2 hardware device since April 2023, which I started using since mid-November 2023 (with v3.0 alpha version). Currently, the 64-bit v4.4

To switch from 32-bit to 64-bit you will need: a new uSD card of good quality, 32GB, a USB stick, so that you can transfer copies from one OS to another, later copy the daily variables here. a lot of

I just found the info in the manual that was just released. Barrel connector is 5.5 x 2.1 mm. Battery needs to provide 3 amps.

I see, so you have the v3.0 alpha version in the firmware on your device. Since development is almost complete on the 32-bit version, it is worth switching to the 64-bit Image if you want to use the

... It is worth switching to the 64-bit OS, because the development is happening here. The current Image contains most of the programs needed for radio broadcasting, which you can implement with this

I hope you have updated the raspberry pi too GMAIL.COM@groups.io> wrote:

Hi Gyula, Thanks for the response. I bought this rig at a tailgate yesterday. The seller seemed like he didn't use it much and was not very helpful. When I click on the icon the software starts fine

Time sync not working - same as reported in issue #4...

Yep, I will flip the version if the early tests find it okay GMAIL.COM@groups.io> wrote:

OK the hardware version is v3, when you turn it on it says which firmware version. Did you just buy it from the manufacturer? Then I think it might be v3.021 or something similar. If you have a spare

v3

Which version? -- Gyula HA3HZ

I have not familiarised myself with this new one, but a common problem is the barrel jack input......ensure you have the correct centre pin sized jack or you wont get connection.....so easy to get

Good morning all, I have been interested in the SDR rig and finally picked one up yesterday. I looked up the manual, watched a few videos but cannot figure out a few things. #1 when i touch the KBD

Uploaded fine ... but shows up as v1.04