开云体育

You might want to look at the Winkeyer by Hamcrafters.? This can take a string of characters from a host system, read them into an internal buffer, and handle correct output timing. Gerry Sherman

If the current source code posted is up-to-date, I don't think an external keyer will help. The pin connected to the key input is being polled within a GUI process by code in ** sbitx_gtk.c .

https://www.hfsignals.com/index.php/zbitx/ Purchasing has been paused while they catch-up from the flood of orders they had in the initial release wrote:

Hi friends, I’m new to these forums and I’m having problems navigating this app; I really don’t know where things are. Please, if anybody could point me in the right direction on how to purchase

Hi Dean, You may boot the rig from the USB pendrive if you change the boot order in your Pi. In the terminal session, you may run "sudo raspi-config", and in the "advanced settings" you may change

Gyula, Here is my plan. I am going to burn a new image on a new 32G card. Open the sBitx and remove the card in the Pi Replace the new card with sb64p3 into the Pi Restart rig How does that

Yes 73, Gwen, NG3P

./update gives 3.021, not 3.05

I ran into this issue as well. See issue #2. I also am still having a difficulty getting FT8 to use the decode selected by clicking the encoder. Something is definitely better because it is no longer

I wanted to check the 64 bit version without disassembling my sBitx v3. It was possible via changing the boot order. The procedure is quite simple. Just run "raspi-config" utility (in the terminal

Updated RPI and then was able to update zBitx SW. All is well now. Tnx, Tom KT4XN ________________________________ Sent: Saturday, March 29, 2025 8:55 PM To: [email protected]

Yes. I have backed up and restored from the 32 bit sd card. I just tried it again this morning with the same results.

Dean, I'm just writing to encourage you that I've had the v2 hardware device since April 2023, which I started using since mid-November 2023 (with v3.0 alpha version). Currently, the 64-bit v4.4

To switch from 32-bit to 64-bit you will need: a new uSD card of good quality, 32GB, a USB stick, so that you can transfer copies from one OS to another, later copy the daily variables here. a lot of

I just found the info in the manual that was just released. Barrel connector is 5.5 x 2.1 mm. Battery needs to provide 3 amps.

I see, so you have the v3.0 alpha version in the firmware on your device. Since development is almost complete on the 32-bit version, it is worth switching to the 64-bit Image if you want to use the

... It is worth switching to the 64-bit OS, because the development is happening here. The current Image contains most of the programs needed for radio broadcasting, which you can implement with this

I hope you have updated the raspberry pi too [email protected]> wrote:

Hi Gyula, Thanks for the response. I bought this rig at a tailgate yesterday. The seller seemed like he didn't use it much and was not very helpful. When I click on the icon the software starts fine

Time sync not working - same as reported in issue #4...