开云体育

I have used No machine for remote access on a different SDR for audio and video both. Haven't tried with the latest sbitx v4.x though. One of the early versions had some mismatch with pipewire on

Got the AC power supply for my zBit this afternoon.? Now all I need is the "wee beastie" itself. Gerry Sherman Sent by the Windows 11 Thunderbird

Hi Edward, The mini end goes in the port on the side of the Nano that faces the Raduino board.

A little something like this…

Just a quick follow-up. Myself, Jon and JJ bought the INA260 boards. Jon came up with a really elegant solution to integrate the board into the radio and has written code to talk to it. We are

I found that cable but could not find where to connect it [email protected]> wrote:

Looking forward to hearing about your experience!

I have made 7 different cards so far. This gives me the ability to go back and restore to a previous version should something go wrong. Now that we are using the 64bit dev team build I would simply

Thank you! t

Hi Ted, This is the one I used on the page you listed.? I used the SSB/CW GP module:

Yeah. Thanks for your help. I do not think Id ever saw that jack.

It might not have been clear from this post: my ?bitx has a BNC AND a 239 connector on the back. Use one, but not both!

That’s impressive! I just looked at https://www.sotabeams.co.uk/audio-filters-and-more/ and did not identify the filter you mentioned. Is that the right place? I’ve a scratch-built audio

To build on what Ted, VA3YWA posted, the alternative supplied has been a board that bolts to the rear panel like this: For this installation, you need one of the cables I have listed. By the way,

On mine, that cable plugged into the Arduino. See attached photo below. An earlier poster wondered about the BNC/239 conundrum. My approach to that problem is also shown in the photo. True: it’s not

Hi Edward, There should have been a USB-A To MiniUSB-B cable in the kit.? Here is the equivalent from Amazon: https://www.amazon.com/Mini-USB-Cable-1-ft-Compatible/dp/B0CXBP2DS1/ Right-angle

I ordered a 20cm 40-pin extension cable. I'll keep you posted!

I assume I sol;der something to something but not know what

I purchased a bnc male to u239 uhf female so the radio will match my antennas

That’s the ‘everything’ cable between an Arduino and the rest of the world. You’ll use it to update the ?bit software or anything else you might want to read from the Arduino. You may never