开云体育

JJ, I'm not very savvy with Linux, at least not to the point of figuring out how to get a piece of hardware working on it. I had to ask my partner to help me get my Ambeserver set to connect headless,

According to PA7LIM's website, AMBE3000 USB devices do not work directly on Linux. I have a DVStick 30 which works on the Windows flavor, but not on Linux. I built and compiled AMBEserver as well, but

We took close to 400 [email protected]> wrote:

Hi Barry, I'm no expert so just sharing my experience.? When i was first playing around investigating i had the radio open and noticed a huge change in hash noise at the target frequency just by

Guys, on the shielding of the display ribbon cable, how many ground connections were used. I wrapped mine and grounded the shield at the display but not at the PI end due to lack of an easy ground

Just incredible work, wow...? few questions for you, the silver box with yellow red and black wires at the bottom, what is that, replacement buck converter?? can you send me a link to what you

I found this link: https://itshamradio.com/bfo-tuning-aid-ubitx/ I have not tried using it, but it connects to my laptop mic and displays the spectrum. 73 Evan AC9TU

Hi Peter, The page displays, but the spectrum analyzer does not appear. I just tried it again, and it has the same symptoms. 73 Evan AC9TU

Hi Evan I had watched the video several times when I first tried setting up, but obviously had forgotten the 'up to 15secs' period. I will try that, it did seem strange that only one sub-routine was

Final shielding for me.

Thank you for introducing your work and for these words you wrote here: -- Gyula HA3HZ

ps,: reverse voltage when it reaches and exceeds the set current the reverse bias: it does not reverse the voltage, but reduces it to the extent that the current consumption exceeds it. -- Gyula

Gordon, I don't have a Zener or suppressor on the gates of the FETs. I think about this differently and only limit the input power for protection. My power supply is a current limiting and has a

Puzzled still how I blew an IRFZ24N (just one -- the other appeared fine) in a highly modified V2 which has huge zeners across the gates to ground which have been shown with oscilloscope photos to

Wonderful problem.? ?How many orders did you take before you stopped?? I am one of the lucky ones waiting anxiously for my delivery. Doug, KI6DS

Greetings Farhan ! Awesome - Can't wait ! Maybe start a list where we can register interest for next round of orders ! 73s

Wb9blw. Looking good! ?I also had the problem with the speaker. ?I made a low profile shield from .030 thick lexan sheet and covered it with copper tape. ?It is secured with 2 of the board of

JJ, Can it be used with the standard setup file for BlueDV? I have a ThumbDV on a Raspberry Pi, with Ambiserver and a port-forwarded hole through my firewall. I use BlueDV for Windows in the house,

great work! [email protected]> wrote:

Ryan, I mocked up some forms to act as a mold for shielding tape yesterday.? The output side had plenty of space to add a full shield and seems like a no brainer. The input side did not have any room