开云体育

Alamogordo Amateur Radio Club Serving Hams In The Tularosa Basin And Around The World And Beyond AARCs' 38th Annual Hamfest 31 Aug Labor Day Weekend 2024 from 7am to 3pm-ish (depends upon

Can you post a pic of the back side to show how you cut out for the Heat Sink? -- '72 Aaron K5ATG ( http://k5atg.com )

For v3, you got the hw_settings.ini with the shipment. If you don't use that, you now learn that the version number hardware settings initialization file cannot be mixed. It's part of the

if you copy v2 folder to v3 most you'll definitely get weird power output, as the calibration is different.

Tnx, I’ll give it a try Tom KT4XN Sent from Mail for Windows Sent: Wednesday, May 15, 2024 4:05 PM To: [email protected] Subject: Re: [BITX20] sBITX V3 output 6 watts Since your

Since your previous question was about that, yes. According to them, you have a v3 that has an IRF510. If you measure a short on either, replace both. If you have a measuring instrument, choose two

I assume you are talking about the IRF510 mosfets? Tom Sent from Mail for Windows Sent: Wednesday, May 15, 2024 2:48 PM To: [email protected] Subject: Re: [BITX20] sBITX V3 output 6

If you are using a non-current-limiting power supply and/or an antenna tuner, it is possible that the output stage fet has failed. -- Gyula HA3HZ

Copied it, no joy. Don’t think it’s the IRF510s Tom KT4XN Sent from Mail for Windows Sent: Wednesday, May 15, 2024 10:47 AM To: [email protected] Subject: Re: [BITX20] sBITX V3

You probably forgot to copy the /sbitx/data folder from the previous version. -- Gyula HA3HZ

I’m running 64k version of Raspberry Pi and my output is a max of 6 watts into a dummy load. My V2 is running the same SW and it’s output is 40 watts. Not sure how to go about troubleshooting.

Jack, It comes as a single board radio and it is also available as a fullt assembled radio in a nice and heavy gauge aluminium chassis with a capacitive touch screen and raspberry pi

My original case that is too big for Ender 3: https://www.thingiverse.com/thing:6445926 But this was remixed by VE9GJ and split so that it will now fit on an ender

Bravo Jeff! I will place my order shortly. Thank you for all of your effort on this update component.

Thank you Ashar. That is a feature I have never noticed. Hopefully I can get some radio play time again soon...staying extremely busy with home chores. Scotty WD4PYT [email protected]> wrote:

Using SSTV with sBitx radio Nothing special happened. I only used the sBitx as a radio in USB mode and a laptop running mmsstv YoniQ 1.13.3 on Windows 10. This is an mmsstv version modified by a

All the parts are in and I tested the board. All looks good except I should have had the connector go out the other side. I had to add a couple washers to allow enough room for the metal plate on the

The switches are connected but they dont do much. The function button, when pressed, shifts the focus to audio control so you can quickly change the volume. The tuning knob is

Another option is a case from Aliexpress that I've used, from David's?post here: /g/BITX20/topic/103816767#msg1108115. His build is a lot tidier than mine!

I thought the sBITX comes with a case. If not, try Thingiverse.com Jack, w8tee