开云体育

To the best of my knowledge and experience, all 2.8" Nextion displays have the same mounting holes.? They need to be filed or Dremmeled out to fit the screw holes and posts on the V6.? The

Oh and I'm also in need of a broadcast filter. I never had any problems and I built a EFHW and now local radio stations are nearly overwhelming the uBITX V6, so again I would appreciate it if anyone

A couple of months back I ordered and received the uBITX AGC kit from INKITS. I went to the INKITS website and tried to find the instructions for the kit and could not find them. I then tried to send

Yes the 2.8 inch Nextion fits in the stock v6 case. Please be aware that the holes in the case and the holes on the Nextion display do not align up properly. Two holes on one side of the Nextion

Is the 2.8 inch Nextion the one that fits the v6 case? Recomended part number for enhanced version? 73 John N4HNO

Try the *Import* button. It will ask to save the adi file. Save to a location and you are done. Bejoy, VU3BOJ

Nick, I am glad that we could help.? Have fun with the uBitx! 73 Evan AC9TU

Congrats Nick!

It lives! Reflowed, rather than replaced, R60. Restored R1 (though your comments noted). Checked resistance - now in order. At the same time, reflowed mic cable both ends, and removed redundant

You are right that the moment when the tuner tunes and the swr is high, that's when the final stage kills you. It's no coincidence that I always say to use a current-limiting power supply and, if

Good info JJ, that's exactly what I needed. While the mosfets where in the board it looked like there was a short between pins, but it kinda drained like a capacitor. So I pulled one off the board and

That is not plastic, that is a mica sheet. It electrically insulates the transistor body (which is connected to the drain at 12v) from the heatsink while providing thermal conductivity to drain away

Well I'm really glad I asked. I would have tossed it right out! I'm assuming heat is what killed my finals, as swr never goes above 1.5 except for a brief moment when my tuner is doing it's thing. So

Aluminum nitride is a better choice for insulators than mica.? The AlN has better heat transfer, and it is almost the same as the aluminum heatsink.? Look for them in normal online places like eBay,

Status update: I have the bare pcbs and encoders. Just waiting for the connectors to show up early next week so I can do a quick test to make sure I didn't mess up. I'm setting up an Etsy store, as

Yeah I would like the opportunity to order a board as well. -- '72 Aaron K5ATG ( http://k5atg.com )

Depending on circuit design and pin layout, it is often necessary to insulate the flat back metallic side of transistors from ground. This used to be done with thin sheets of mica with heat sink

I believe so, mine has that as well -- '72 Aaron K5ATG ( http://k5atg.com )

Is there supposed to be a piece of plastic between the IRF510s and the heatsink? (The smaller oval shaped piece.)